MC68HC908EY8A中文资料飞思卡尔数据手册PDF规格书

Introduction

The MC68HC908EY16A is a member of the low-cost, high-performance M68HC08 Family of 8-bit microcontroller units (MCUs). All MCUs in the family use the enhanced M68HC08 central processor unit (CPU08) and are available with a variety of modules, memory sizes and types, and package types.

The information contained in this document pertains to the MC68HC908EY8A with the exceptions noted in Appendix A MC68HC908EY8A.

Features

For convenience, features have been organized to reflect:

• Standard features of the MC68HC908EY16A

• Features of the CPU08

Standard features of the MC68HC908EY16A include:

• High-performance M68HC08 architecture optimized for C-compilers

• Fully upward-compatible object code with M6805, M146805, and M68HC05 Families

• 8-MHz internal bus frequency at 5V

• Internal oscillator requiring no external components:

– Software selectable bus frequencies

– 25 percent accuracy with a trimming capability of better than 1 percent

– Clock monitor

– Option to allow use of external clock source or external crystal/ceramic resonator

• 15,872 bytes of on-chip FLASH memory with in-circuit programming

• FLASH program memory security(1)

• 512 bytes of on-chip random-access memory (RAM)

• Low voltage inhibit (LVI) module

• Internal clock generator module (ICG)

• Two 16-bit, 2-channel timer (TIMA and TIMB) interface modules with selectable input capture, output compare, and pulse-width modulation (PWM) capability on each channel

• 8-channel, 10-bit successive approximation analog-to-digital converter (ADC)

• Enhanced serial communications interface module (ESCI) for local interconnect network (LIN) connectivity

• Serial peripheral interface (SPI)

• Timebase Module (TBM)

• 5-bit keyboard wakeup port with software selectable rising or falling edge detect, as well as highor low-level detection

– Programmable for rising/falling edge or high/low level detection

• 24 general-purpose input/output (I/O) pins

• External asynchronous interrupt pin with internal pullup (IRQ)

• System protection features:

– Optional computer operating properly (COP) reset

– Illegal opcode detection with reset

– Illegal address detection with reset

• 32-pin quad flat pack (QFP) package

• Low-power design; fully static with stop and wait modes

• Internal pullups on IRQ and RST to reduce customer system cost

• Standard low-power modes of operation:

– Wait mode

– Stop mode

• Master reset pin (RST) and power-on reset (POR)

• BREAK module (BRK) to allow single breakpoint setting during in-circuit debugging

• Higher current source capability on nine port lines for LED drive (PTA6/SS, PTA5/SPSCK, PTA4/KBD4, PTA3/KBD3/RxD, PTA2/KBD2/TxD, PTA1/KBD1, PTA0/KBD0, PTC1/MOSI, and PTC0/MISO)

Features of the CPU08 include:

• Enhanced HC05 programming model

• Extensive loop control functions

• 16 addressing modes (eight more than the HC05)

• 16-bit index register and stack pointer

• Memory-to-memory data transfers

• Fast 8 x 8 multiply instruction

• Fast 16 x 8 divide instruction

• Binary-coded decimal (BCD) instructions

• Optimization for controller applications

• Third party C language support