MBM29PL160BD-90PF中文资料富士通数据手册PDF规格书

■ GENERAL DESCRIPTION

The MBM29PL160TD/BD is a 16M-bit, 3.0 V-only Flash memory organized as 2M bytes of 8 bits each or 1M words of 16 bits each. The MBM29PL160TD/BD is offered in a 48-pin TSOP (I), and 44-pin SOP packages. The device is designed to be programmed in-system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The device can also be reprogrammed in standard EPROM programmers.

■ FEATURES

• Single 3.0 V read, program and erase

Minimizes system level power requirements

• Compatible with JEDEC-standard commands

Uses same software commands as E2PROMs

• Compatible with MASK ROM pinouts

48-pin TSOP (I) (Package suffix: PFTN-Normal Bend Type, PFTR-Reversed Bend Type)

44-pin SOP (Package suffix: PF)

• Minimum 100,000 program/erase cycles

• High performance

25 ns maximum page access time (75ns maximum random access time)

• An 8 words page read mode function

• Sector erase architecture

One 8K word, two 4K words, one 112K word, and seven 128K words sectors in word mode

One 16K byte, two 8K bytes, one 224K byte, and seven 256K bytes sectors in byte mode

Any combination of sectors can be concurrently erased. Also supports full chip erase

• Boot Code Sector Architecture

T = Top sector

B = Bottom sector

• Embedded EraseTM Algorithms

Automatically pre-programs and erases the chip or any sector

• Embedded programTM Algorithms

Automatically programs and verifies data at specified address

• Data Polling and Toggle Bit feature for detection of program or erase cycle completion

• Ready/Busy output (RY/BY)

Hardware method for detection of program or erase cycle completion

• Automatic sleep mode

When addresses remain stable, automatically switches themselves to low power mode

• Low VCC write inhibit ≤ 2.5 V

• Erase Suspend/Resume

Suspends the erase operation to allow a read data and/or program

in another sector within the same device

• Sector protection

Hardware method disables any combination of sectors from program or erase operations

• Temporary sector unprotection

Temporary sector unprotection with the software command

• 5V tolerant (Data, Address, and Control Signals)

• In accordance with CFI (Common Flash Memory Interface)