MBM29LV652UE90PBT中文资料富士通数据手册PDF规格书

■ GENERAL DESCRIPTION

The MBM29LV652UE is a 64M-bit, 3.0 V-only Flash memory organized as 4M words of 16 bits each. The device is designed to MBM29LV652UEbe programmed in system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The devices can also be reprogrammed in standard EPROM programmers.

■ FEATURES

• 0.23 µm Process Technology

• Single 3.0 V read, program and erase

Minimizes system level power requirements

• Compatible with JEDEC-standards

Uses same software commands with single-power supply Flash

• Address don’t care during the command sequence

• Industry-standard pinouts

63-ball FBGA (Package suffix: PBT)

• Minimum 100,000 program/erase cycles

• High performance

90 ns maximum access time

• Flexible sector architecture

One hundred twenty-eight 32K word sectors

Any combination of sectors can be concurrently erased. Also supports full chip erase

• Hidden ROM (Hi-ROM) region

128 word of Hi-ROM, accessible through a new “Hi-ROM Enable” command sequence

Factory serialized and protected to provide a secure electronic serial number (ESN)

• Ready/Busy Output (RY/BY)

Hardware method for detection of program or erase cycle completion

• ACC input pin

At VACC, increases program performance

• Embedded EraseTM* Algorithms

Automatically pre-programs and erases the chip or any sector

• Embedded programTM* Algorithms

Automatically writes and verifies data at specified address

• Data Polling and Toggle Bit feature for detection of program or erase cycle completion

• Automatic sleep mode

When addresses remain stable, automatically switches themselves to low power mode

• Low VCC write inhibit ≤ 2.5 V

• Erase Suspend/Resume

Suspends the erase operation to allow a read data and/or program in another sector within the same device

• Sector group protection

Hardware method disables any combination of sector groups from program or erase operations

• Sector Group Protection Set function by Extended sector protect command

• Fast Programming Function by Extended Command

• Temporary sector group unprotection

Temporary sector group unprotection via the RESET pin

This feature allows code changes in previously locked sectors

• In accordance with CFI (Common Flash Memory Interface)