MBM29DL800BA-90PBT中文资料飞索数据手册PDF规格书

■ GENERAL DESCRIPTION

The MBM29DL800TA/BA are a 8M-bit, 3.0 V-only Flash memory organized as 1M bytes of 8 bits each or 512K words of 16 bits each. The MBM29DL800TA/BA are offered in a 48-pin TSOP(I) and 48-ball FBGA packages. These devices are designed to be programmed in-system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The devices can also be reprogrammed in standard EPROM programmers.

■ FEATURES

• Single 3.0 V read, program, and erase

Minimizes system level power requirements

• Simultaneous operations

Read-while-Erase or Read-while-Program

• Compatible with JEDEC-standard commands

Uses same software commands as E2PROMs

• Compatible with JEDEC-standard world-wide pinouts (Pin compatible with MBM29LV800TA/BA)

48-pin TSOP(I) (Package suffix: PFTN – Normal Bend Type, PFTR – Reversed Bend Type)

48-ball FBGA (Package suffix: PBT)

• Minimum 100,000 program/erase cycles

• High performance

70 ns maximum access time

• Sector erase architecture

Two 16K byte, four 8K bytes, two 32K byte, and fourteen 64K bytes.

Any combination of sectors can be concurrently erased. Also supports full chip erase.

• Boot Code Sector Architecture

T = Top sector

B = Bottom sector

• Embedded EraseTM Algorithms

Automatically pre-programs and erases the chip or any sector

• Embedded ProgramTM Algorithms

Automatically writes and verifies data at specified address

• Data Polling and Toggle Bit feature for detection of program or erase cycle completion

• Ready/Busy output (RY/BY)

Hardware method for detection of program or erase cycle completion

• Automatic sleep mode

When addresses remain stable, automatically switch themselves to low power mode.

• Low VCC write inhibit ≤ 2.5 V

• Erase Suspend/Resume

Suspends the erase operation to allow a read in another sector within the same device

• Sector protection

Hardware method disables any combination of sectors from program or erase operations

• Sector Protection Set function by Extended sector protection command

• Fast Programming Function by Extended Command

• Temporary sector unprotection

Temporary sector unprotection via the RESET pin.