MAX809Z数据手册集成电路（IC）的监控器规格书PDF

描述 Description

The MAX803/MAX809/MAX810 are microprocessor (µP) supervisory circuits used to monitor the power supplies in µP and digital systems. They provide excellent circuit reliability and low cost by eliminating external components and adjustments when used with +5V, +3.3V, +3.0V, or +2.5V powered circuits.
These circuits perform a single function: they assert a reset signal whenever the VCC supply voltage declines below a preset threshold, keeping it asserted for at least 140ms after VCC has risen above the reset threshold. Reset thresholds suitable for operation with a variety of supply voltages are available.
The MAX803 has an open-drain output stage, while the MAX809/MAX810 have push-pull outputs. The MAX803's open-drain active-low RESET output requires a pullup resistor that can be connected to a voltage higher than VCC. The MAX803/MAX809 have an active-low RESET output, while the MAX810 has an active-high RESET output. The reset comparator is designed to ignore fast transients on VCC, and the outputs are guaranteed to be in the correct logic state for VCC down to 1V.
Low supply current makes the MAX803/MAX809/MAX810 ideal for use in portable equipment. The MAX803 is available in a 3-pin SC70 package, and the MAX809/MAX810 are available in 3-pin SC70 or SOT23 packages.

特性 Features

• Precision Monitoring of +2.5V, +3V, +3.3V, and +5V Power-Supply Voltages
• Fully Specified Over Temperature
• Available in Three Output Configurations
• Open-Drain Active-Low RESET Output (MAX803)
• Push-Pull Active-Low RESET Output (MAX809)
• Push-Pull RESET Output (MAX810)
• 140ms min Power-On Reset Pulse Width
• 12µA Supply Current
• Guaranteed Reset Valid to VCC= +1V
• Power Supply Transient Immunity
• No External Components
• 3-Pin SC70 and SOT23 Packages
• AEC-Q100 Qualified. Refer to Ordering Information for Specific /V Versions

应用 Application

• 汽车
• 计算机：台式机、工作站和服务器
• 控制器
• 精确的µP与µC电源监控
• 智能仪表
• 便携式电池供电设备

简介

MAX809Z属于集成电路（IC）的监控器。由制造生产的MAX809Z监控器PMIC 监控器用于监视和/或控制电路中的电压轨，能够连接微控制器以维持一定的功率限值。监控器类型包括电池备用电路、监控器、多电压监控器、电源监控器、稳压器/监控器、复位计时器、定序器、简单复位/上电复位、智能开/关控制器、系统管理器、电压检测器和看门狗电路。