MAX3237EIPWR集成电路（IC）的驱动器接收器收发器规格书PDF中文资料

MAX3237EIPWR属于集成电路（IC）的驱动器接收器收发器。由德州仪器制造生产的MAX3237EIPWR驱动器，接收器，收发器该系列产品的主要功能是提供必需的硬件资源，以通过延长电缆或印制线进行通信。确切的功能会因所采用的通信协议而异，可能包括诸如瞬态抑制之类的功能，这些功能对于通信用途可能并非绝对必要，但对于可能的使用环境却是明智之选。

FEATURES

• Meets or Exceeds the Requirements of

TIA/EIA-232-F and ITU v.28 Standards

• Operates With 3-V to 5.5-V VCC Supply

• Operates From 250 kbits/s to 1 Mbit/s

• Low Standby Current . . . 1 mA Typical

• External Capacitors . . . 4 × 0.1 mF

• Accepts 5-V Logic Input With 3.3-V Supply

• Designed to Be Interchangeable With Maxim

MAX3237E

• Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

• ESD Protection for RS-232 I/O Pins

– ±15 kV – Human-Body Model (HBM)

– ±8 kV – IEC61000-4-2, Contact Discharge

– ±15 kV – IEC61000-4-2, Air-Gap Discharge

APPLICATIONS

• Battery-Powered, Hand-Held, and Portable

Equipment

• PDAs and Palmtop PCs

• Notebooks, Sub-Notebooks, and Laptops

• Digital Cameras

• Mobile Phones and Wireless Devices

DESCRIPTION

The MAX3237E consists of five line drivers, three line receivers, and a dual charge-pump circuit with ±15-kV

ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of

TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the

serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to

5.5-V supply. This device operates at data signaling rates of 250 kbit/s in normal operating mode

(MBAUD = GND) and 1Mbit/s when MBAUD = VCC. The driver output slew rate is a maximum of 30 V/ms.

The MAX3237E transmitters are disabled and the outputs are forced into high-impedance state when the device

is in shutdown mode (SHDN = GND) and the supply current falls to less than 1 mA. Also, during shutdown, the

onboard charge pump is disabled; V+ is lowered to VCC, and V– is raised toward GND. Receiver outputs also

can be placed in the high-impedance state by setting enable (EN) high. ROUT1B remains active all the time,

regardless of the EN and SHDN condition.

The MAX3237EC is characterized for operation from 0°C to 70°C. The MAX3237EI is characterized for operation

from –40°C to 85°C.