7.5kVRMS SPI/Digital or I2C 關Module Isolator with Transformer Driver

DESCRIPTION The LTM®2810 is a complete galvanic digital μModule® (micromodule) isolator. No external components are required. Individual 3V to 5.5V supplies power each side of the digital isolator. Separate logic supply pins allow easy interfacing with different logic levels from 1.62V to 5.

文件：1.3482 Mbytes 页数：30 Pages

AD

亚德诺

6500VRMS Isolated RS485/RS422 μModule Transceiver Power

FEATURES - RS485/RS422 Transceiver: 6500VRMS for 1 Minute - CSA (IEC/UL) Approved, File #255632 - Isolated DC Power: 5V at 200mA - No External Components Required - 20Mbps or Low EMI 250kbps Data Rate - High ESD: ±15kV HBM on Transceiver Interface - High Common Mode Transient Immunity: 50kV

文件：1.59431 Mbytes 页数：22 Pages

AD

亚德诺

I2C Slave Device Extender Over Rugged Differential Link

DESCRIPTION The LTC®4331 is a point-to-point SMBus compatible I2C slave device extender designed for operation in high noise industrial environments. Using a ±60V fault protected differential transceiver, the LTC4331 can extend an I2C/ SMBus bus, including SMBALERT and a control signal, over

文件：242.47 Kbytes 页数：26 Pages

AD

亚德诺

SPI Extender Over Rugged Differential Link

DESCRIPTION The LTC®4332 is a point-to-point rugged SPI extender designed for operation in high noise industrial environments over long distances. Using a ±60V fault protected differential transceiver, the LTC4332 can transmit SPI data, including an interrupt signal, up to 2MHz over two twist

文件：1.43605 Mbytes 页数：22 Pages

AD

亚德诺

Isolated USB Data Transceiver

FEATURES - Isolated USB Transceiver: 7500VRMS for 1 Minute - CSA (IEC/UL) Approved, File #255632 - Reinforced Insulation - USB 2.0 Full Speed and Low Speed Compatible - Auto-Configuration of Bus Speed - 4.4V to 36V VBUS and VBUS2 Operating Range - 3.3V LDO Output Supply Signal References VL

文件：671.83 Kbytes 页数：18 Pages

AD

亚德诺

Isolated USB Transceiver with Isolated Power

FEATURES - LTM2884: 2500VRMS for 1 Minute - LTM2884(a): 3000VRMS for 1 Minute - LTM2884: UL Recognized File #E151738 - LTM2884(a): CSA Recognized File #255632 - USB 2.0 Full Speed and Low Speed Compatible - Integrated Isolated DC/DC Converter, External or Bus Powered - Auto-Configuration o

文件：1.42709 Mbytes 页数：24 Pages

AD

亚德诺

SPI/Digital or I2C 關Module Isolator with Adjustable 짹12.5V and 5V Regulated Power

文件：759.29 Kbytes 页数：36 Pages

LINER

凌力尔特

SPI/Digital or I2C 關Module Isolator with Adjustable 짹12.5V and 5V Regulated Power

文件：761.99 Kbytes 页数：36 Pages

LINER

凌力尔特

具可调 ±12.5V 和 5V 稳定电源的 SPI / 数字或 I2C μModule 隔离器

LTM®2883 是一款完整的电流数字 µModule® 隔离器。其无需使用外部组件。单个 3.3V 或 5V 电源通过一个集成型隔离式 DC/DC 转换器为接口的两侧供电。一个逻辑电源引脚提供了与 1.62V 至 5.5V 不同逻辑电平的简易连接，这与主电源无关。\n\n可用选项符合 SPI 和 I2C (仅限主控器模式) 规范。\n\n隔离侧包括标称值为 ±12.5V 和 5V 的电源，它们各能提供 20mA 以上的负载电流。每个电源都可以采用单个外部电阻器从其标称值进行调节。\n\n耦合电感器和一个隔离式电源变压器在输入和输出逻辑接口之间提供了 2500VRMS 的隔离度。该器件非常适合 • 达到 UL1577 规格可在 1 分钟承受 2500VRMS \n\n• UL 认证文件编号 E151738 \n\n\n\n\n• 隔离型可调 DC 电源： \n•3V 至 5V (在高达 30mA) \n\n• ±12.5V (在高达 20mA) \n\n\n\n\n• 无需外部组件\n\n• SPI (LTM2883-S) 或 I2C (LTM2883-I) 选项\n\n• 可承受高共模瞬变：30kV/μs\n\n• 高速操作： \n\n• 10MHz 数字隔离 \n•4MHz / 8MHz SPI 隔离 \n\n• 400kHz I2C 隔离 \n\n\n\n\n• 3.3V (L;

ADI

亚德诺

SPI/Digital or I2C 關Module Isolator with Adjustable 짹12.5V and 5V Regulated Power

文件：761.99 Kbytes 页数：36 Pages

LINER

凌力尔特