LPC2214FBD144

单芯片16/32位Arm微控制器；128/256 kB ISP/IAP闪存，带10位ADC和外部存储器接口; 2.1 Key features brought by LPC2212/2214/01 devices\n• Fast GPIO ports enable port pin toggling up to 3.5 times faster than the original device. They also allow for a port pin to be read at any time regardless of its function.\n• Dedicated result registers for ADC(s) reduce interrupt overhead. The ADC pads are 5 V tolerant when configured for digital I/O function(s).\n• UART0/1 include fractional baud rate generator, auto-bauding capabilities and handshake flow-control fully implemented in hardware.\n• Buffered SSP serial controller supporting SPI, 4-wire SSI, and Microwire formats.\n• SPI programmable data length and master mode enhancement.\n• Diversified Code Read Protection (CRP) enables different security levels to be implemented. This feature is available in LPC2212/2214/00 devices as well.\n• General purpose timers can operate as external event counters.\n2.2 Key features common for all devices\n• 16/32-bit Arm7TDMI-S™ microcontroller in a LQFP144 package.\n• 16 kB on-chip static RAM and 128/256 kB on-chip flash program memory. 128-bit wide interface/accelerator enables high speed 60 MHz operation.\n• In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or full chip erase takes 400 ms.\n• EmbeddedICE-RT and Embedded Trace interfaces offer real-time debugging with the on-chip RealMonitor software as well as high speed real-time tracing of instruction execution.\n• Eight-channel 10-bit ADC with conversion time as low as 2.44 µs.\n• Two 32-bit timers (with four capture and four compare channels), PWM unit (six outputs), Real-Time Clock and Watchdog.\n• Multiple serial interfaces including two UARTs (16C550), Fast I²C-bus (400 kbit/s) and two SPIs.\n• Vectored Interrupt Controller with configurable priorities and vector addresses.\n• Configurable external memory interface with up to four banks, each up to 16 MB and 8/16/32-bit data width.\n• Up to 112 general purpose I/O pins (5 V tolerant). Up to nine edge or level sensitive external interrupt pins available.\n• 60 MHz maximum CPU clock available from programmable on-chip Phase-Locked Loop with settling time of 100 µs.\n• On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz.\n• Two low power modes, Idle and Power-down.\n• Processor wake-up from Power-down mode via external interrupt.\n• Individual enable/disable of peripheral functions for power optimization.\n• Dual power supply: • CPU operating voltage range of 1.65 V to 1.95 V (1.8 V ± 0.15 V).\n• I/O power supply range of 3.0 V to 3.6 V (3.3 V ± 10 %) with 5 V tolerant I/O pads.\n;

The LPC2212/2214 are based on a 16/32-bit Arm7TDMI-S™ CPU with real-time emulation and embedded trace support, together with 128/256 kB of embedded high-speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 % with minimal performance penalty.\nWith their 144-pin package, low power consumption, various 32-bit timers, 8-channel 10-bit ADC, PWM channels and up to nine external interrupt pins these microcontrollers are particularly suitable for industrial control, medical systems, access control and point-of-sale. Number of available fast GPIOs ranges from up to 76 pins (with external memory) through up to 112 pins (single-chip). With a wide range of serial communications interfaces, they are also very well suited for communication gateways, protocol converters and embedded soft modems as well as many other general-purpose applications.\nRemark: Throughout the data sheet, the term LPC2212/2214 will apply to devices with and without the /00 or /01 suffixes. The /00 or the /01 suffix will be used to differentiate from other devices only when necessary.\n

LPC2214FBD144

16/32-bit ARM microcontrollers; 128/256 kB ISP/IAP Flash with 10-bit ADC and external memory interface

Generaldescription TheLPC2212/LPC2214arebasedona16/32bitARM7TDMI-S™CPUwithreal-timeemulationandembeddedtracesupport,togetherwith128/256kilobytes(kB)ofembeddedhighspeedflashmemory.A128-bitwidememoryinterfaceandauniqueacceleratorarchitectureenable32-bitcod

LPC2214FBD144

16/32-bit ARM microcontrollers; 128/256 kB ISP/IAP flash with 10-bit ADC and external memory interface

LPC2214FBD14400

16/32-bit ARM microcontrollers; 128/256 kB ISP/IAP flash with 10-bit ADC and external memory interface

LPC2214FBD14401

16/32-bit ARM microcontrollers; 128/256 kB ISP/IAP flash with 10-bit ADC and external memory interface

ME2214

MEWTF-2214-B

Plug-inSignalConditionersM-UNIT

MEWTF-2214-BSLASHCE

Plug-inSignalConditionersM-UNIT

MEWTF-2214-C

Plug-inSignalConditionersM-UNIT

MEWTF-2214-CSLASHCE

Plug-inSignalConditionersM-UNIT