LMH6517中文资料具有数字控制增益的低功耗、低噪声 IF 和基带双路 16 位 ADC 驱动器数据手册TI规格书

描述 Description

The LMH6517 contains two high performance, digitally controlled variable gain amplifiers (DVGA). It has been designed for use in narrowband and broadband IF sampling applications. Typically the LMH6517 drives a high performance ADC in a broad range of mixed signal and digital communication applications such as mobile radio and cellular base stations where automatic gain control (AGC) is required to increase system dynamic range.
Each channel of LMH6517 has an independent, digitally controlled attenuator and a high linearity, differential output amplifier. Each block has been optimized for low distortion and maximum system design flexibility. Each channel can be individually disabled for power savings.
The LMH6517 digitally controlled attenuator provides precise 0.5dB gain steps over a 31.5dB range. On chip digital latches are provided for local storage of the gain setting. Both serial and parallel programming options are provided. A Pulse mode is also offered where simple up or down commands can change the gain one step at a time.
The output amplifier has a differential output allowing large signal swings on a single 5V supply. The low impedance output provides maximum flexibility when driving filters or analog to digital converters.
The LMH6517 operates over the industrial temperature range of −40°C to +85°C. The LMH6517 is available in a 32-Pin, thermally enhanced, WQFN package.

特性 Features

• Accurate, 0.5dB Gain Steps
• Low Impedance, Differential Output
• Parallel Gain Control
• Two Wire, Pulse Mode Control
• Low Sensitivity of Linearity and Phase to Gain Setting
• Small Footprint WQFN Package
• Noise figure 5.5dB
• Gain step accuracy: 0.05dB
• Supply current 80mA per channel