LM5025B中文资料具有 P 或 N 沟道钳位 FET 和 75% 最大占空比的 90V 有源钳位电压模式 PWM 控制器数据手册TI规格书

描述 Description

The LM5025B is a functional variant of the LM5025 active clamp PWM controller. The functional differences of the LM5025B are as follows: The maximum PWM duty cycle is limited to less than 75% to reduce voltage stress on the power MOSFETs. The CS2 hiccup mode threshold is increased to 0.5V The CS2 filter discharge device is disabled The VCC regulator continues to operate when the line UVLO is below the threshold of normal operation The VREF regulator is switched off when the line UVLO input falls below the operating threshold The internal 5kΩ COMP pin pull-up resistor is removed The LM5025B PWM controller contains all of the features necessary to implement power converters utilizing the Active Clamp / Reset technique. With the active clamp technique, higher efficiencies and greater power densities can be realized compared to conventional catch winding or RDC clamp / reset techniques. Two control outputs are provided, the main power switch control (OUT_A) and the active clamp switch control (OUT_B). The two internal compound gate drivers parallel both MOS and Bipolar devices, providing superior gate drive characteristics. This controller is designed for high-speed operation including an oscillator frequency range up to 1MHz and total PWM and current sense propagation delays less than 100ns. The LM5025B includes a high-voltage start-up regulator that operates over a wide input range of 13V to 100V. Additional features include: Line Under Voltage Lockout (UVLO), softstart, oscillator UP/DOWN sync capability, precision reference and thermal shutdown.

特性 Features

• Internal Start-Up Bias Regulator
• Programmable Line Under-Voltage Lockout (UVLO) with Adjustable Hysteresis
• Adjustable Dual Mode Over-Current Protection
• Volt x Second Maximum Duty Cycle Clamp
• Current Sense Leading Edge Blanking
• Oscillator Up / Down Sync Capability
• Thermal Shutdown
• TSSOP-16
• WSON-16 (5x5 mm) Thermally Enhanced