LM20124MHXSLASHNOPB.A中文资料德州仪器数据手册PDF规格书

1FEATURES

2• LM20124-Q1 is AEC-Q100 qualified and

manufactured on an Automotive Grade Flow

• Input voltage range 2.95V to 5.5V

• Accurate current limit minimizes inductor size

• 96% efficiency at 1 MHz switching frequency

• 32 mΩ integrated FET switches

• Starts up into pre-biased loads

• Output voltage tracking

• Peak current mode control

• Adjustable output voltage down to 0.8V

• Adjustable Soft-Start with external capacitor

• Precision enable pin with hysteresis

• Integrated OVP, UVLO, power good and

thermal shutdown

• TSSOP 16 pin exposed pad package

APPLICATIONS

• Simple to design, high efficiency point of load

regulation from a 5V or 3.3V bus

• High Performance DSPs, FPGAs, ASICs and

microprocessors

• Broadband, Networking and Optical

Communications Infrastructure

DESCRIPTION

The LM20124 is a full featured 1 MHz synchronous

buck regulator capable of delivering up to 4A of

continuous output current. The current mode control

loop can be compensated to be stable with virtually

any type of output capacitor. For most cases,

compensating the device only requires two external components, providing maximum flexibility and ease

of use. The device is optimized to work over the input

voltage range of 2.95V to 5.5V making it suited for a

wide variety of low voltage systems.

The device features internal over voltage protection

(OVP) and over current protection (OCP) circuits for increased system reliability. A precision enable pin

and integrated UVLO allows the turn-on of the device

to be tightly controlled and sequenced. Start-up

inrush currents are limited by both an internally fixed

and externally adjustable Soft-Start circuit. Fault detection and supply sequencing is possible with the

integrated power good circuit.

The LM20124 is designed to work well in multi-rail

power supply architectures. The output voltage of the

device can be configured to track a higher voltage rail

using the SS/TRK pin. If the output of the LM20124 is

pre-biased at startup it will not sink current to pull the

output low until the internal soft-start ramp exceeds

the voltage at the feedback pin.

The LM20124 is offered in a 16-pin TSSOP package

with an exposed pad that can be soldered to the

PCB, eliminating the need for bulky heatsinks.