Sample-and-hold amplifiers

DESCRIPTION The LF198/LF298/LF398 are monolithic sample-and-hold circuits which utilize high-voltage ion-implant JFET technology to obtain ultra-high DC accuracy with fast acquisition of signal and low droop rate. Operating as a unity gain follower, DC gain accuracy is 0.002 typical and acquisiti

文件：129.16 Kbytes 页数：5 Pages

PHI

PHI

MONOLITHIC SAMPLE AND HOLD CIRCUITS

GENERAL DESCRIPTION The LF198/LF298/LF398 are BI-FET monolithic sample and hold circuits with ultra-high DC accuracy, fast acquisition time (6μ to 0.01) and low droop rate. A bipolar input stage is used to obtain the lowest possible offset voltage and wide bandwidth.

文件：257.2 Kbytes 页数：7 Pages

ETCList of Unclassifed Manufacturers

未分类制造商

Precision Sample and Hold Amplifier

文件：1.07393 Mbytes 页数：16 Pages

LINER

凌力尔特

Monolithic Sample-and-Hold Circuits

文件：520.789 Kbytes 页数：13 Pages

NSC

国半

LF198/LF298/LF398, LF198A/LF398A Monolithic Sample-and-Hold Circuits

文件：564.8 Kbytes 页数：15 Pages

TI

德州仪器

Precision Sample and Hold Amplifier

OBSOLETE PRODUCT Data Sheet For Reference Only \nThe LF198 is a precision sample and hold amplifier which uses a combination of bipolar and junction FET transistors to provide precision, high speed, and long hold times. A typical offset voltage of 1mV and gain error of 0.002% allow this sample a ·Guaranteed 6µs Max. Acquisition Time\n·Guaranteed 0.005% Max. Gain Error\n·Guaranteed 1mV Max. Offset Voltage\n·Guaranteed 1mV Max. Hold Step\n·Very Low Feedthrough 86dB Min.\n·High Input Impedance under All Conditions\n·Logic Inputs Compatible with All Logic Families;

ADI

亚德诺

Sample-and-hold amplifiers

恩XP

LFx98x Monolithic Sample-and-Hold Circuits

1 Features 1• Operates from ±5-V to ±18-V Supplies • Less than 10-μs Acquisition Time • Logic Input Compatible With TTL, PMOS, CMOS • 0.5-mV Typical Hold Step at Ch = 0.01 μF • Low Input Offset • 0.002% Gain Accuracy • Low Output Noise in Hold Mode • Input Characteristics Do Not Change

文件：3.23114 Mbytes 页数：41 Pages

TI

德州仪器

LFx98x Monolithic Sample-and-Hold Circuits

1 Features 1• Operates from ±5-V to ±18-V Supplies • Less than 10-μs Acquisition Time • Logic Input Compatible With TTL, PMOS, CMOS • 0.5-mV Typical Hold Step at Ch = 0.01 μF • Low Input Offset • 0.002% Gain Accuracy • Low Output Noise in Hold Mode • Input Characteristics Do Not Change

文件：3.23114 Mbytes 页数：41 Pages

TI

德州仪器

Sample-and-hold amplifiers

DESCRIPTION The LF198/LF298/LF398 are monolithic sample-and-hold circuits which utilize high-voltage ion-implant JFET technology to obtain ultra-high DC accuracy with fast acquisition of signal and low droop rate. Operating as a unity gain follower, DC gain accuracy is 0.002 typical and acquisiti

文件：129.16 Kbytes 页数：5 Pages

PHI

PHI