Configurable octal serial switch with open load detect current disable

Features • Designed to operate 5.5 V

文件：1.01188 Mbytes 页数：26 Pages

freescaleFreescale Semiconductor, Inc

飞思卡尔飞思卡尔半导体

SBC Gen2 with CAN high speed and LIN interface

The 33903/4/5 is the second generation family of the System Basis Chip (SBC). It combines several features and enhances present module designs. The device works as an advanced power management unit for the MCU with additional integrated circuits such as sensors and CAN transceivers. It has a built

文件：3.06724 Mbytes 页数：111 Pages

恩XP

SBC Gen2 with CAN high speed and LIN interface

The 33903/4/5 is the second generation family of the System Basis Chip (SBC). It combines several features and enhances present module designs. The device works as an advanced power management unit for the MCU with additional integrated circuits such as sensors and CAN transceivers. It has a built

文件：3.06724 Mbytes 页数：111 Pages

恩XP

Multiple Switch Detection Interface with Suppressed Wake-up and 32 mA Wetting Current

Features • Designed to operate from 5.5 V  VPWR  28 V • Switch input voltage: (33975: -14 to 38 V) (33975A: -14 to 40 V) • Interfaces to microprocessor using 3.3 V/5.0 V SPI protocol • Selectable wake-up on change of state • 14 switch-to-ground inputs • 8 programmable inputs (switches to b

文件：951.39 Kbytes 页数：32 Pages

freescaleFreescale Semiconductor, Inc

飞思卡尔飞思卡尔半导体

Single Intelligent High-current Self protected High-side Switch

Features • Single 2.0 m max high-side switch with parallel input or SPI control • 6.0 V to 27 V operating voltage with standby currents

文件：888.02 Kbytes 页数：37 Pages

freescaleFreescale Semiconductor, Inc

飞思卡尔飞思卡尔半导体

Dual Intelligent High-current Self-protected Silicon High Side Switch (8.0 mOhm)

Features •Dual 8.0 mΩ max high side switch with parallel input or SPI control •6.0V to 27 V operating voltage with standby currents

文件：1.59375 Mbytes 页数：34 Pages

恩XP

High Input Voltage 600mA Charger for Single-cell Li-Ion Batteries

The MC34671 is a cost-effective fully-integrated battery charger for Li-Ion or Li-Polymer batteries. The high input voltage, up to 28V, eliminates the input over-voltage-protection circuit required in handheld devices such as cell phones, Bluetooth accessories and MP3 players. A typical charge cy

文件：831.93 Kbytes 页数：22 Pages

恩XP

High Input Voltage Travel Charger for Single-cell Li-Ion Batteries

Features • No external MOSFET, reverse-blocking diode or currentsense resistor are required • 28 V maximum input voltage rating with 11 V over-voltage protection threshold • Factory programmable charge current • Trickle charge for fully discharged batteries • ±0.4% voltage accuracy over

文件：958.96 Kbytes 页数：26 Pages

freescaleFreescale Semiconductor, Inc

飞思卡尔飞思卡尔半导体

28V-Input-Voltage Single-Cell Li-Ion Battery Charger with 10mA Regulator

Features • No external MOSFET, reverse-blocking diode, or current-sense resistor is required • Guaranteed maximum 1A programmable CC mode current • ±0.7% voltage accuracy over -40°C to 85°C • ±6% current accuracy over -40°C to 85°C • 4.85V/10mA linear regulator with a 6.8V input over-

文件：639.71 Kbytes 页数：24 Pages

freescaleFreescale Semiconductor, Inc

飞思卡尔飞思卡尔半导体

Multiple Channel DC-DC Power Management IC

Features • 8 DC/DC (34704A) or 5 DC/DC (34704B) switching regulators with up to 2% output voltage accuracy • Dynamic voltage scaling on all regulators. • Selectable output voltage or current regulation on REG8 • I2C programmability • Output undervoltage and overvoltage detection for eac

文件：2.59622 Mbytes 页数：54 Pages

freescaleFreescale Semiconductor, Inc

飞思卡尔飞思卡尔半导体