ISOW1044DFMR集成电路（IC）的驱动器接收器收发器规格书PDF中文资料

ISOW1044DFMR属于集成电路（IC）的驱动器接收器收发器。由德州仪器制造生产的ISOW1044DFMR驱动器，接收器，收发器该系列产品的主要功能是提供必需的硬件资源，以通过延长电缆或印制线进行通信。确切的功能会因所采用的通信协议而异，可能包括诸如瞬态抑制之类的功能，这些功能对于通信用途可能并非绝对必要，但对于可能的使用环境却是明智之选。

1 Features

• Meets the requirements of ISO 11898-2:2016

physical layer standards

– Support of Classical CAN: 1 Mbps

– Optimized for CAN FD: 2 and 5 Mbps

• Integrated DC-DC converter with low-emissions,

low-noise

– Meets CISPR 32 and EN 55032 Class B with

greater than 6 dB margin on a two-layer PCB

– Low frequency power converter at 25 MHz

enabling low noise performance

• Additional 10 Mbps GPIO channel

• High efficiency output power

– Typical efficiency: 47%

– Isolated output voltage accuracy: ± 5%

– Additional output current: 20 mA

• Independent power supply for CAN & DC-DC

– Logic supply (VIO): 1.71 V to 5.5 V

– Power converter supply ( VDD): 4.5 V to 5.5 V

• Fault-Protected CAN FD Transceiver

– DC Bus fault protection voltage: ± 58V

– Receiver common mode input voltage: ±12 V

– Remote wakeup via BUS wake-up pattern

• Typical loop delay: 167 ns

• Reinforced and Basic isolation options

• High CMTI: 100-kV/μs (typical)

• High ESD bus protection w.r.t GND2

– HBM ESD: ±12 kV

– IEC 61000-4-2 contact discharge: ±8 kV

• Operating temperature range: -40°C to 125°C

• Current limit and thermal shutdown

• 20-pin wide SOIC package

• Safety-Related Certifications planned:

– VDE Reinforced and Basic insulation per DIN

VDE V 0884-11:2017-01

– UL 1577 component recognition program

– IEC 62368-1, IEC 61010-1, IEC 60601-1 and

GB 4943.1-2011 certifications

2 Applications

• Factory Automation

• Building Automation

• Industrial Transport

• Solar Inverters, Protection Relay

• Motor Drives

3 Description

The ISOW1044 device is a galvanically-isolated

controller area network (CAN) transceiver with a

built-in isolated DC-DC converter that eliminates the

need for a separate isolated power supply in spaceconstrained

isolated designs. The low-emissions,

isolated DC-DC meets CISPR 32 radiated emissions

Class B standard with just two ferrite beads on

a simple two-layer PCB. Additional 20 mA output

current can be used to power other circuits on the

board. An integrated 10 Mbps GPIO channel is

available and can help remove an additional digital

isolator or optocoupler for diagnotstics, LED indication

or supply monitoring.