ISOUSB211-Q1中文资料德州仪器数据手册PDF规格书

1 Features

• Compliant to USB 2.0

• Supports low speed (1.5 Mbps), full speed (12

Mbps) and high speed (480 Mbps) signaling

• Does not need external crystal or clock input

• Automatic speed and connection detection

• Supports L1 (sleep) and L2 (suspend) low-power

states

• Programmable equalization to compensate board

trace loss in high speed mode

• CDP advertising on downstream side

• Supply OK indication on opposite side

• Supports automatic role reversal for USB On-The-

Go (OTG) and Type-C® Dual Role Port (DRP)

designs

• High CMTI: 100 kV/μs

• ±8 kV IEC 61000-4-2 contact discharge protection

across isolation barrier

• VBUS voltage range: 4.25 V to 5.5 V

– 3.3 V and 1.8 V internal LDOs

• Meets CISPR32 class B emissions limits

• Ambient temperature range: –40°C to +125°C

• Small footprint 28-SSOP package

• Safety-related certifications:

– 7071-VPK VIOTM and 2121-VPK VIORM

(Reinforced) per DIN EN IEC 60747-17 (VDE

0884-17)

– 5000-VRMS isolation for 1 minute per UL 1577

– IEC 62368-1, IEC 60601-1 and IEC 61010-1

certifications

– CQC, TUV and CSA certifications

2 Applications

• USB Hub, Host, Peripheral and Cable Isolation

• Medical

• Factory automation

• Motor drives

• Grid infrastructure

• Power delivery

• USB Audio

3 Description

ISOUSB211-Q1 is a galvanically-isolated USB 2.0

compliant repeater supporting low speed (1.5 Mbps),

full speed (12 Mbps) and high speed (480 Mbps)

signaling rates. The device supports automatic

connect and speed detection, reflection of pull-ups/

pull-downs, and link power management allowing

drop-in USB hub, host, peripheral and cable isolation.

The device also supports automatic role reversal

- if after disconnect, a new connect is detected

on the Upstream facing port, then the Upstream

and Downstream port definitions are reversed.

This feature enables the device to support USB

On-The-Go (OTG) and Type-C Dual Role Port

(DRP) implementations. The ISOUSB211-Q1 has

inbuilt programmable equalization to cancel signal

loss caused by board traces, which helps in

meeting USB2.0 high-speed TX and RX eye-diagram

templates. This device uses a silicon dioxide (SiO2)

insulation barrier with a withstand voltage of up to

5000 VRMS and a working voltage of 1500 VRMS. Used

in conjunction with isolated power supplies, the device

protects against high voltage, and prevents noise

currents from the bus from entering the local ground.

The ISOUSB211-Q1 device is available for reinforced

isolation. It supports a wide ambient temperature

range of –40°C to +125°C. The device is available in

the small foot-print SSOP-28 (28-DP) package.