OPIC Light Detector for X40 Speed CD-ROM Drive

General Description Sharps IS1682 is OPIC light detectors which are used for pick-up in X40 speed CD-ROM drive. They improve noise resistance characteristics and enable to read low reflective CD-RW due to built-in RF amp. Features (1) High speed response(Response frequency: MIN. 45MHz) (Best su

文件：53.88 Kbytes 页数：2 Pages

SHARPSharp Corporation

夏普

OPIC Light Detector for X40 Speed CD-ROM Drive

Sharp

夏普

Bluetooth v.3.0+EDR Dual-MIC Multimedia SOC

The IS1682S is a highly integrated ultra-low power, single-chip RF and baseband IC for Bluetooth v3.0+EDR Single/Dual-MIC applications. The IS1682S builds in an audio processor and high performance stereo codec to support the enhanced audio and speech. To provide superior audio and voice quality, it • Compliant with Bluetooth Specification v.3.0 + EDR in 2.4GHZ ISM band\n• Class 2 Bluetooth radio with +4dBm transmit power and -91dBm receiver sensitivity\n• 16-bit/32-bit run time configurable audio processor\n• HFP v1.6 includes wideband speech and mSBC codec\n• Multipoint HFP connection to 2 ph;

Microchip

微芯科技

Doubler Charge Pumps with Low Noise Linear Regulator

文件：186.92 Kbytes 页数：12 Pages

LINER

凌力尔特

Switched-Capacitor Voltage Doublers

General Description The ultra-small MAX1682/MAX1683 monolithic, CMOS charge-pump voltage doublers accept input voltages ranging from +2.0V to +5.5V. Their high voltage-conversion efficiency (over 98) and low operating current (110µA for MAX1682) make these devices ideal for both battery-powered a

文件：81.82 Kbytes 页数：8 Pages

MAXIM

美信

Integrated Circuit Pre-Amplifier Circuit for Remote Control Signal Receivers

Description: The NTE1682 is an integrated circuit in a 9–Lead SIP type package designed for use in infrared and various types of remote control signal receivers. Features: • High Sensitivity, High Gain, Low Noise • Waveform Shaping Circuit • Voltage Regulator Circuit

文件：20.82 Kbytes 页数：2 Pages

NTE