HMT151R7AFP8C中文资料海力士数据手册PDF规格书

Description

This Hynix DDR3 SDRAM Registered Dual In-Line Memory Module (DIMM) series consists of 1Gb A generation. These are intended for use as main memory in server and workstation systems, providing a high performance 8 byte interface in 133.35mm width form factor of industry standard. It is suitable for easy interchange and addition.

Features

• VDD=VDDQ=1.5V

• VDDSPD=3.3V to 3.6V

• Fully differential clock inputs (CK, CK) operation

• Differential Data Strobe (DQS, DQS)

• On chip DLL align DQ, DQS and /DQS transition with CK transition

• DM masks write data-in at the both rising and falling edges of the data strobe

• All addresses and control inputs except data, data strobes and data masks latched on the rising edges of the clock

• Programmable CAS latency 5, 6, 7, 8, 9, 10, and (11) supported

• Programmable additive latency 0, CL-1, and CL-2 sup ported

• Programmable CAS Write latency (CWL) = 5, 6, 7, 8

• Programmable burst length 4/8 with both nibble sequential and interleave mode

• BL switch on the fly

• 8 banks

• 8K refresh cycles /64ms

• DDR3 SDRAM Package: JEDEC standard 78ball FBGA(x4/x8), 96ball FBGA(x16) with support balls

• Driver strength selected by EMRS

• Dynamic On Die Termination supported

• Asynchronous RESET pin supported

• ZQ calibration supported

• TDQS (Termination Data Strobe) supported (x8 device based only)

• Write Levelization supported

• Auto Self Refresh supported

• 8 bit pre-fetch

• Heat Spreader installed for 4GB/8GB

• SPD with Integrated TS of Class B