HIP4020IB集成电路（IC）的全半桥驱动器规格书PDF中文资料

In the Functional Block Diagram of the HIP4020, the four

switches and a load are arranged in an H-Configuration so

that the drive voltage from terminals OUTA and OUTB can

be cross-switched to change the direction of current flow in

the load. This is commonly known as 4-quadrant load

control. As shown in the Block Diagram, switches Q1 and Q4

are conducting or in an ON state when current flows from

VDD through Q1 to the load, and then through Q4 to terminal

VSSB; where load terminal OUTA is at a positive potential

with respect to OUTB. Switches Q1 and Q4 are operated

synchronously by the control logic. The control logic

switches Q3 and Q2 to an open or OFF state when Q1 and

Q4 are switched ON. To reverse the current flow in the load,

the switch states are reversed where Q1 and Q4 are OFF

while Q2 and Q3 are ON. Consequently, current then flows

from VDD through Q3, through the load, and through Q2 to

terminal VSSA, and load terminal OUTB is then at a positive

potential with respect to OUTA.

Terminals ENA and ENB are ENABLE Inputs for the Logic A

and B Input Controls. The ILF output is an Overcurrent Limit

Fault Flag Output and indicates a fault condition for either

Output A or B or both. The VDD and VSS are the Power

Supply reference terminals for the A and B Control Logic

Inputs and ILF Output. While the VDD positive power supply

terminal is internally connected to each bridge driver, the

VSSA and VSSB Power Supply terminals are separate and

independent from VSS and may be more negative than the

VSS ground reference terminal. The use of level shifters in

the gate drive circuitry to the NMOS (low-side) output stages

allows controlled level shifting of the output drive relative to

ground.

Features

• Two Independent Controlled Complementary MOS Power

Output Half H-Drivers (Full-Bridge) for Nominal 3V to 12V

Power Supply Operation

• Split Voltage Power Supply Option for Output Drivers

• Load Switching Capabilities to 0.5A

• Single Supply Range +2.5V to +15V

• Low Standby Current

• CMOS/TTL Compatible Input Logic

• Over-Temperature Shutdown Protection

• Overcurrent Limit Protection

• Overcurrent Fault Flag Output

• Direction, Braking and PWM Control

• Pb-Free Plus Anneal Available (RoHS Compliant)

Applications

• DC Motor Driver

• Relay and Solenoid Drivers

• Stepper Motor Controller

• Air Core Gauge Instrument Driver

• Speedometer Displays

• Tachometer Displays

• Remote Power Switch

• Battery Operated Switch Circuits

• Logic and Microcontroller Operated Switch