GPM6P1015A中文资料16-pin LRC with 16KB OTP ROM数据手册Generalplus规格书

描述 Description

GPM6P1015A is chip especially designed for remote control featuring 256 bytes built-in SRAM and 16K bytes built-in OTP ROM.  It includes three Timers and up to 13 software selectable general I/Os.  Additionally, it provides one frequency programmable and duty selectable Pulse Width Modulation (PWM) output for remote control.  And it provides built-in capture mode timer for input signal frequency detecting by infrared learning function.  It operates over a wide voltage range of 2.0V - 3.6V@4MHz.  It has a SLEEP mode for power savings which retains RAM's contents, but stops the oscillator and causes all other functions to be inoperative.  The SLEEP mode can be released by using external wakeup sources.  In addition, it provides a FREEZE mode to save power and to lock keyboard when power-supply voltage is detected lower than VLVR.  In FREEZE mode, CPU and peripheral are stopped, and all I/Os maintain floating with input function disabled.  The FREEZE mode releases when power-supply voltage recover from VLVR.  Especially, it has a very accuracy internal OSC, which matches the specification ±1.5%(typ) @ 2.0V~3.6V  Meanwhile, the built-in IR transfer module can make IR control and utilization easily.

特性 Features

• CPU
• 151 instructions
• 13 addressing modes
• Up to 8MHz clock operation

• Memories
• 16K bytes program OTP ROM
• 256 bytes RAM including stack area

• Reset Management
• Enhanced reset system
• Power On Reset (POR)
• Low Voltage Reset (LVR)
• Watchdog Reset (WDR)

• Interrupt Management
• 8 internal interrupts

• I/O Ports
• Max. 12 (GPM6P1015A) multifunction bi-directional I/Os. And each body has a VPP pin with input (with pull low or high resistor) and output low multifunction.
• Each incorporates with pull-up resistor, pull-down resistor or floating input, depending on programmer's settings on the corresponding registers.
• I/O ports with LED driving capability
• I/O ports with 16mA sink current

• Clock Management
• Internal oscillator: 4MHz or 8MHz (selectable by code option) ±1.5%(typ), @ 2.0V~3.6V
• Crystal input: 4~ 8MHz @ 2.0V~3.6V

• Power Management
• Two power saving modes: SLEEP, FREEZE modes

• One Analog Peripheral
• LVR: Low Voltage Reset (1.85V or 2.25V selectable through code option)

• 12-bit up-count or 8-bit down-count Selectable (by SFR) Timer (Timer A)
• Timer mode with clock source selectable
• PWM output in carrier signal mode with duty and driver current programmable
• PWM output in no carrier signal mode with driver current programmable
• Capture the input signal frequency
• Detect the signal envelop

• 12-bit up-count or down-count Selectable (by SFR) Timer (Timer B)
• Timer mode with clock source selectable
• Timer A's carry signal can be its clock source

• Watchdog Timer
• Frequency: 0.95Hz @4MHz(System Clock)

• Key Wakeup
• Key change wake-up from SLEEP mode

• IR
• Built-in IR TX can drive IR LED with up to 200mA driving capability @ VDD=3.0V & VRMT=3.0V.
• Built-in IR RX can supply capture function with sensitivity adjustable. (2uA, 5uA, 8uA, 11uA)