F81535中文资料eSPI/LPC/USB/PCIE I/F Controller数据手册FINTEK规格书

描述 Description

F81535 is the ideal bridge between USB to Octa (8) UART controller and which is complies with USB 2.0 as well as the standard serial port specification. Each UART includes 128-byte send/receive FIFO, a baud rate generator, complete modem control capability an interrupt system.(1)The F81535 will enter suspend mode when suspend signaling is detected on the bus. Upon entering suspend mode, the F81535 asserts the SUSPEND and SUSPEND# signals. The SUSPEND and SUSPEND# signals are also asserted after the F81535 reset until device configuration during USB enumeration is complete. The F81535 exits the suspend mode when any of the following occur: resume signaling is detected or generated, a USB Reset signal is detected, or a device reset occurs. On exit of suspend mode, the SUSPEND and SUSPEND# signals are de-asserted.(1)The device built in +1.8V & +3.3V LDO regulators.(1)(1)

特性 Features

➢ Support the Octa RS-232/RS-485/RS-422 Serial interface with the transfer Data Rate & Baud Rate
➢ All UARTs Support HW Auto Flow Control Function
➢ 128-byte Receive/Send FIFO
➢ Support USB 2.0 Specification High Speed (480Mbps) & Full Speed (12Mbps)
➢ Built in 1.8 & 3.3V LDO
➢ USB Suspend & Resume Conditions Supported Via Suspend & RI# pins
➢ Support External Crystal 12MHz
➢ Support Plug & Play
➢ Support 12 GPIO pins
➢ Support -40°C~85°C Industrial Temperature Range
➢ ESD Protection: HBM ± 2KV, MM ± 200V, CDM ± 500V, Latch-up Free
➢ Related USB Drivers are Available
128-pin LQFP (14*14mm)