STEPPER MOTOR CONTROLLER

Description The ELM311 is an interface circuit for use between high speed logic and four phase stepper motor driver circuits. All of the logic required to provide stepping in two directions is contained in this one 8 pin package. This circuit supports only one mode of operation, the full-ste

文件：31.82 Kbytes 页数：5 Pages

ELM

Stepper Motor Controller

The ELM311 is an interface circuit for use between high speed logic and four phase stepper motor driver circuits. All of the logic required to provide stepping in two directions is contained in this one 8 pin package.\n\n This circuit supports only one mode of operation, the full-step, or single ·Low power CMOS design – typically 1mA at 5V\n·Wide supply range – 3.0 to 5.5 volt operation\n·Two inputs control Full step motion\n·No external timing components\n·Completely static operation – will maintain a step position indefinitely\n·High current drive outputs – up to 25 mA\n·Very high speed –;

ELM

STEPPER MOTOR CONTROLLER

Description The ELM311 is an interface circuit for use between high speed logic and four phase stepper motor driver circuits. All of the logic required to provide stepping in two directions is contained in this one 8 pin package. This circuit supports only one mode of operation, the full-ste

文件：31.82 Kbytes 页数：5 Pages

ELM

STEPPER MOTOR CONTROLLER

Description The ELM311 is an interface circuit for use between high speed logic and four phase stepper motor driver circuits. All of the logic required to provide stepping in two directions is contained in this one 8 pin package. This circuit supports only one mode of operation, the full-ste

文件：31.82 Kbytes 页数：5 Pages

ELM

STEPPER MOTOR CONTROLLER

Description The ELM311 is an interface circuit for use between high speed logic and four phase stepper motor driver circuits. All of the logic required to provide stepping in two directions is contained in this one 8 pin package. This circuit supports only one mode of operation, the full-ste

文件：31.82 Kbytes 页数：5 Pages

ELM