ECT25S16数据手册E-CMOS中文资料规格书

描述 Description

The ECT25S16  is 16M-bit Serial Peripheral Interface(SPI) Flash memory, and supports the Dual/ Quad SPI: Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO), I/O2 (/WP), and I/O3(/HOLD). The Dual I/O data is transferred with speed of 216Mbits/s and the Quad I/O & Quad output data is transferred with speed of 432Mbits/s. The device uses a single low voltage power supply, ranging from 2.7 Volt to 3.6 Volt.

Additionally, the device supports JEDEC standard manufacturer and device ID and three 256-bytes Security Registers.

In order to meet environmental requirements, E-CMOS offers an 8-pin SOP 150-mil,173-mil  or 208mil,an 8-pad WSON 6x5-mm.



 

 

特性 Features

● Serial Peripheral Interface(SPI)
- Standard SPI: SCLK, /CS, SI, SO, /WP, /HOLD
- Dual SPI: SCLK, /CS, IO0, IO1, /WP, /HOLD
- Quad SPI: SCLK, /CS, IO0, IO1, IO2, IO3
 
● Read
- Normal Read (Serial): 50MHz clock rate
- Fast Read (Serial): 108MHz clock rate
- Dual/Quad (Multi-I/O) Read: 108MHz clock rate
 
● Program
- Serial-input Page Program up to 256bytes
- Program Suspend and Resume
 
● Erase
- Block erase (64/32 KB)
- Sector erase (4 KB)
- Chip erase
- Erase Suspend and Resume
 
● Program/Erase Speed
- Page Program time: 0.7ms typical  
- Sector Erase time: 60ms typical
- Block Erase time: 0.2/0.4s typical
- Chip Erase time: 15s typical
 
● Flexible Architecture
- Sector of 4K-byte
- Block of 32/64K-byte
 
● Low Power Consumption
- 20mA maximum active current
- 5uA maximum power down current
 
 ● Software/Hardware Write Protection
- 3x256-Byte Security Registers with OTP Lock
- Enable/Disable protection with WP Pin
- Write protect all/portion of memory via software
- Top or Bottom, Sector or Block selection
 
● Single Supply Voltage
- Full voltage range: 2.7~3.6V
 
● Temperature Range
- Commercial (0℃ to +70℃)
- Industrial (-40℃ to +85℃)
 
● Cycling Endurance/Data Retention
- Typical 100k Program-Erase cycles on any sector
- Typical 20-year data retention at +55℃