EC24C1024A中文资料1024K bits Two-wire Serial EEPROM数据手册E-CMOS规格书

描述 Description

The EC24C1024A are EEPROM devices that use the industrial standard 2-wire interface for communications. The EC24C1024A contains a memory array of 1024K-bits (131,072x8), which is organized in 25-byte per page. The EEPROM can operate in a wide voltage range from 1.7V to 5.5V which fits most application. This product can

provide a low-power 2-wire EEPROM solution. The device is offered in Lead-free, RoHS, halogen free or Green. The available package types are 8-pin SOP, TSSOP.

The EC24C1024A is compatible with the industrial standard 2-wire bus protocol. If in case the bus is not responded, a new sent Op-code command will reset the bus and the device will respond correctly. The simple bus consists of the Serial Clock wire (SCL) and the Serial Data wire (SDA).

Utilizing such bus protocol, a Master device, such as a microcontroller, can usually control one or more Slave devices, alike this EC24C1024A. The bit stream over the SDA line includes a series of bytes, which identifies a particular Slave device, an instruction, an address within that Slave

 

device, and a series of data, if appropriate. The EC24C1024A also has a Write Protect pin (WP) to allow blocking any write operations over specified memory area.

Under no circumstance, the device will be hung up. In order to refrain the state machine entering into a wrong state during power-up sequence or a power toggle off-on

condition, a power on reset circuit is embedded. During

power-up, the device does not respond to any instructions

until the supply voltage (VCC) has reached an acceptable

stable level above the reset threshold voltage. Once VCC

passes the power on reset threshold, the device is reset

and enters into the Standby mode. This would also avoid

any inadvertent Write operations during power-up stage.

During power-down process, the device will enter into

standby mode, once VCC drops below the power on reset

threshold voltage. In addition, the device will be in standby

mode after receiving the Stop command, provided that no

internal write operation is in progress. Nevertheless, it is

illegal to send a command unless the VCC is within its

operating level.

 

特性 Features

● Two-Wire Serial Interface, I2CTM Compatible
– Bi-directional data transfer protocol
● Wide-voltage Operation
– VCC = 1.7V to 5.5V
● Speed: 400 KHz (1.7V) and 1 MHz (2.5V~5.5V)
● Standby current (max.): 1uA, 1.7V
● Read Operating current (max.): 1 mA, 1.7V
● Write Operating current(max.)：3mA, 1.7V
● Hardware Data Protection
– Write Protect Pin
● Sequential & Random Read Features
● Memory organization: 131,072 x 8 bits
 
 
● Page Size: 256 bytes
● Page write mode
– Up to 256 bytes per page write
● Self timed write cycle with auto clear: 5ms (max.)
● Filtered inputs for noise suppression
● High-reliability
– Endurance: 1 million cycles
– Data retention: 100 years
● Industrial temperature grades
● Packages: SOP/TSSOP 8L
● Lead-free, RoHS, Halogen free, Green