DS90CF383BMTSLASHNOPB.A中文资料德州仪器数据手册PDF规格书

1FEATURES

23• No Special Start-up Sequence Required

Between Clock/Data and /PD Pins. Input Signal

(Clock and Data) Can be Applied Either Before

or After the Device is Powered.

• Support Spread Spectrum Clocking Up to

100KHz Frequency Modulation & Deviations of

±2.5% Center Spread or −5% Down Spread.

• Input Clock Detection Feature Will Pull All

LVDS Pairs to Logic Low when Input Clock is

Missing and When /PD Pin is Logic High.

• 18 to 68 MHz Shift Clock Support

• Best–in–Class Set & Hold Times on TxINPUTs

• Tx Power Consumption < 130 mW (typ)

@65MHz Grayscale

• 40% Less Power Dissipation Than BiCMOS

Alternatives

• Tx Power-down Mode < 60μW (typ)

• Supports VGA, SVGA, XGA and Dual Pixel

SXGA.

• Narrow Cus Reduces Cable Size and Cost

• Up to 1.8 Gbps Throughput

• Up to 227 Megabytes/sec Bandwidth

• 345 mV (typ) Swing LVDS Devices for Low EMI

• PLL Requires No External Components

• Compatible with TIA/EIA-644 LVDS Standard

• Low Profile 56-Lead TSSOP Package

• Improved Replacement for:

– SN75LVDS83, DS90CF383A

DESCRIPTION

The DS90CF383B transmitter converts 28 bits of

CMOS/TTL data into four LVDS (Low Voltage

Differential Signaling) data streams. A phase-locked

transmit clock is transmitted in parallel with the data streams over a fifth LVDS link. Every cycle of the

transmit clock 28 bits of input data are sampled and

transmitted. At a transmit clock frequency of 65 MHz,

24 bits of RGB data and 3 bits of LCD timing and

control data (FPLINE, FPFRAME, DRDY) are

transmitted at a rate of 455 Mbps per LVDS data

channel. Using a 65 MHz clock, the data throughput is 227 Mbytes/sec. The DS90CF383B is fixed as a

Falling edge strobe transmitter and will interoperate

with a Falling edge strobe Receiver (DS90CF386)

without any translation logic.

This chipset is an ideal means to solve EMI and

cable size problems associated with wide, high speed

TTL interfaces.