DS90C383MTDXSLASHNOPB中文资料德州仪器数据手册PDF规格书

General Description

The DS90C383 transmitter converts 28 bits of LVCMOS/

LVTTL data into four LVDS (Low Voltage Differential Signaling)

data streams. A phase-locked transmit clock is transmitted

in parallel with the data streams over a fifth LVDS link.

Every cycle of the transmit clock 28 bits of input data are

sampled and transmitted. The DS90CF384 receiver converts

the LVDS data streams back into 28 bits of LVCMOS/

LVTTL data. At a transmit clock frequency of 65 MHz, 24 bits

of RGB data and 3 bits of LCD timing and control data

(FPLINE, FPFRAME, DRDY) are transmitted at a rate of 455

Mbps per LVDS data channel. Using a 65 MHz clock, the

data throughputs is 227 Mbytes/sec. The transmitter is offered

with programmable edge data strobes for convenient

interface with a variety of graphics controllers. The transmitter

can be programmed for Rising edge strobe or Falling

edge strobe through a dedicated pin. A Rising edge transmitter

will inter-operate with a Falling edge receiver

(DS90CF384) without any translation logic. Both devices are

also offered in a 64 ball, 0.8mm fine pitch ball grid array

(FBGA) package which provides a 44 % reduction in PCB

footprint compared to the TSSOP package.

This chipset is an ideal means to solve EMI and cable size

problems associated with wide, high speed TTL interfaces.

特性 Features

20 to 65 MHz shift clock support

Programmable transmitter (DS90C383) strobe select

Rising or Falling edge strobe)

Single 3.3V supply

Chipset (Tx + Rx) power consumption < 250 mW (typ)

Power-down mode (< 0.5 mW total)

Single pixel per clock XGA (1024x768) ready

Supports VGA, SVGA, XGA and higher addressability.

Up to 227 Megabytes/sec bandwidth

Up to 1.8 Gbps throughput

Narrow bus reduces cable size and cost

290 mV swing LVDS devices for low EMI

PLL requires no external components

Low profile 56-lead TSSOP package.

Also available in a 64 ball, 0.8mm fine pitch ball grid

array (FBGA) package

Falling edge data strobe Receiver

Compatible with TIA/EIA-644 LVDS standard

ESD rating >7 kV

Operating Temperature: −40°C to +85°C