DS90C365A集成电路（IC）的驱动器接收器收发器规格书PDF中文资料

DS90C365A属于集成电路（IC）的驱动器接收器收发器。由德州仪器制造生产的DS90C365A驱动器，接收器，收发器该系列产品的主要功能是提供必需的硬件资源，以通过延长电缆或印制线进行通信。确切的功能会因所采用的通信协议而异，可能包括诸如瞬态抑制之类的功能，这些功能对于通信用途可能并非绝对必要，但对于可能的使用环境却是明智之选。

1FEATURES

23• Pin-to-pin compatible to DS90C363,

DS90C363A and DS90C365

• No special start-up sequence required

between clock/data and /PD pins. Input signals

(clock and data) can be applied either before

or after the device is powered.

• Support Spread Spectrum Clocking up to

100kHz frequency modulation & deviations of

±2.5% center spread or -5% down spread.

• “Input Clock Detection” feature will pull all

LVDS pairs to logic low when input clock is

missing and when /PD pin is logic high.

• 18 to 87.5 MHz shift clock support

• Tx power consumption < 146 mW (typ) at 87.5

MHz Grayscale

• Tx Power-down mode < 37 uW (typ)

• Supports VGA, SVGA, XGA, SXGA (dual pixel),

SXGA+ (dual pixel), UXGA (dual pixel).

• Narrow bus reduces cable size and cost

• Up to 1.785 Gbps throughput

• Up to 223.125 Megabytes/sec bandwidth

• 345 mV (typ) swing LVDS devices for low EMI

• PLL requires no external components

• Compliant to TIA/EIA-644 LVDS standard

• Low profile 48-lead TSSOP package

DESCRIPTION

The DS90C365A is a pin to pin compatible

replacement for DS90C363, DS90C363A and

DS90C365. The DS90C365A has additional features

and improvements making it an ideal replacement for

DS90C363, DS90C363A and DS90C365. family of

LVDS Transmitters.

The DS90C365A transmitter converts 21 bits of

LVCMOS/LVTTL data into four LVDS (Low Voltage

Differential Signaling) data streams. A phase-locked

transmit clock is transmitted in parallel with the data

streams over the fourth LVDS link. Every cycle of the

transmit clock 21 bits RGB of input data are sampled

and transmitted. At a transmit clock frequency of 87.5

MHz, 21 bits of RGB data and 3 bits of LCD timing

and control data (FPLINE, FPFRAME, DRDY) are

transmitted at a rate of 612.5 Mbps per LVDS data

channel. Using a 87.5 MHz clock, the data throughput

is 229.687 Mbytes/sec. This transmitter can be

programmed for Rising edge strobe or Falling edge

strobe through a dedicated pin. A Rising edge or

Falling edge strobe transmitter will interoperate with a

Falling edge strobe FPDLink Receiver without any

translation logic.

This chipset is an ideal means to solve EMI and

cable size problems associated with wide, high-speed TTL interfaces with added Spead Spectrum Clocking

support..