DS80CH11数据手册ADI中文资料规格书

描述 Description

The system energy manager is a highly integrated microcontroller that provides several key features for systems including key scanning and control, battery and power management, as well as two 2-Wire serial I/O Ports. It incorporates the Dallas 8051-compatible high-speed microcontroller core which has been redesigned to eliminate wasted clock and memory cycles. Every standard 8051 instruction is executed between 1.5 and 3 times faster than the original for the same crystal speed. Looking at it another way, the high-speed core achieves the same throughput as a standard 8051 while using much less power as a result of fewer required clock cycles. As a result, the firmware can easily support many tasks required by mobile systems within a single component.
The controller is designed to off-load battery and power management tasks from the host CPU and thereby make possible an efficient solution for systems. In addition to the microcontroller core, it incorporates an 8-channel, 10-bit A/D converter with external reference so that its firmware can perform battery management tasks without burdening the host CPU. A four-channel 8-bit pulse-width modulator allows digital control of functions such as LCD contrast and brightness. An 8-bit port is provided for key scan inputs. A total of 88 parallel I/O pins are available for key scanning, system configuration, and power management control.
The system energy manager scans a key matrix and interfaces to the host CPU via an 8042-compatible port. The benefits of sophisticated power management and permanently powered functions are thereby attained without adding to the system's chip count.
Two 2-wire, bi-directional serial buses are incorporated to facilitate the management of slave peripheral devices on the motherboard, such as digital temperature sensors and potentiometers, and to support external low-speed I/O devices such as monitor configuration channels, pen tablets, and joysticks.
Because a direct interface to the X-bus is provided, the controller is not dependent on a particular core logic chip or chip set. Independent chip select inputs for the keyboard controller, power management #1, and power management #2 registers are provided.

特性 Features

·High speed 80C32 compatible core:

·High performance 4 clocks/machine cycles (8032 = 12)
·Low Power: typically 1/3 power for equivalent 8032 throughput
·Maximum clock speed up to 25MHz at 5.0V
·Ultra-low stop mode power (typ. 1uA) \"IDLE\" mode (typ. 10mA)
·Multiple wake-up sources from STOP including key scan, 2-wire, host I/F, or external interrupt
·Three 16-bit timers, 1 serial port
·256-byte scratchpad
·256 bytes MOVX RAM

·Keyboard Control:

·Replaces 8042 and key scan microcontroller
·2 Parallel I/O ports for key scan outputs
·One interrupt-driven 8-bit input port to initiate key-scan sequence

·Input/Output:

·Total of eleven 8-bit I/O ports; all pins can individually programmed to serve as general purpose digital input/output.
·8-bit port supports one or more special functions:

·Port 0, 2, 3: external program/data memory interface
·Port 1, 3: UART, 2-Wire serial, timers, external interrupt I/O.
·Port 4, 8, 9: Key scan input/output
·Port 5: A/D inputs
·Port 6: PWM Outputs
·Port 7: activity monitor, LED control
·Port 10: GPIO


·Analog input/output:

·Eight-channel, 10-bit A/D with power down mode supports charging NiMH rechargeable cells
·4-channel, 8-bit PWM supports LCD brightness and contrast control

·2-Wire bi-directional serial buses

·Master/slave multi-drop operation
·Manages on-board slaves or external I/O devices

·Power Control

·Generates system power on reset
·Programmable power down pin states