TRI-STATE(RM) Quad 2-Data Selectors/Multiplexers

文件：413.55 Kbytes 页数：10 Pages

TI

德州仪器

TRI-STATE Quad 2-Data Selectors/Multiplexers

文件：163.7 Kbytes 页数：8 Pages

NSC

国半

TRI-STATE Quad 2-Data Selectors/Multiplexers

文件：163.7 Kbytes 页数：8 Pages

NSC

国半

8-Bit Addressable Latches

文件：153.55 Kbytes 页数：6 Pages

NSC

国半

8-Bit Addressable Latches

文件：153.55 Kbytes 页数：6 Pages

NSC

国半

8-Bit Addressable Latches

文件：153.55 Kbytes 页数：6 Pages

NSC

国半

8-Bit Addressable Latches

文件：153.55 Kbytes 页数：6 Pages

NSC

国半

TRI-STATE® Data Selectors/Multiplexers

General Description\nThese data selectors/multiplexers contain full on-chip binary decoding to select one-of-eight data sources, and feature a strobe-controlled TRI-STATE output. The strobe must be at a low logic level to enable these devices. The TRI-STATE outputs permit direct connection to a comm YTRI-STATE version of LS151\nYInterface directly with system bus\nYPerform parallel-to-serial conversion\nYPermit multiplexing from N-lines to one line\nYComplementary outputs provide true and inverted data\nMaximum number of common outputs\n        54LS        49\n        74LS        129\nTypical p;

TI

德州仪器

TRI-STATE® Data Selectors/Multiplexers

General Description\nEach of these Schottky-clamped data selectors/multiplexers contains inverters and drivers to supply fully complementary, on-chip, binary decoding data selection to the AND-OR gates. Separate output control inputs are provided for each of the two four-line sections. The TRI-STATE TRI-STATE version of LS153 with same pinout\nSchottky-diode-clamped transistors\nPermit multiplexing from N-lines to one line\nPerforms parallel-to-serial conversion\nStrobe/output control\nHigh fanout totem-pole outputs\nTypical propagation delay\n  Data to output 12 ns\n  Select to output 21 ns\nT;

TI

德州仪器