D2011M中文资料GMI数据手册PDF规格书

General description:

D2000M series Intrinsically Safe Multiplexing System consists of one to four

Analog-Temperature Multiplexer units model D2010M, up to twelve Expander units

model D2011M, or up to four Digital Multiplexer units model D2030M, mounted in

Hazardous Area/Hazardous Locations Zone 1-2, Gas Group IIC-IIB-IIA T4 or

Class I, Division 1-2, Group A, B, C, D T4 and connected via a single/redundant 2 wires

data communication/supply line to a Modbus Gateway unit model D2050M,

mounted in Safe Area/Non Hazardous Locations and connected to a PLC, DCS or PC.

Multiplexer Expander D2011M units can be installed in the field, close to input sensors,

for data acquisition of signal from Hazardous Area/Hazardous Locations Zone 0-1-2 or

Class I, Class II, Class III, Division 1-2.

The units are primarily intended for Hazardous Area/Hazardous Locations acquisition of

low level signals from mV, thermocouples, thermoresistances or mA (via external shunt

device like D1090Q four channel shunt resistor) sources.

D2011M scans all channels using state of the art solid state isolated relays, and stores

all data in the D2010M memory buffer connected to it, where they can be rapidly

accessed by the Modbus Gateway D2050M unit.

Each D2011M unit accepts directly up to 16 input channels.

An integrating type, high rejection, high accuracy (18 bits) A/D converter installed on

D2010M unit that control up to three Expander D2011M, provides accurate and stable

measurements. All parameters are software configurable by serial commands via

D2050M Gateway unit and stored in the D2010M unit connected to the Expander.

Features:

• Intrinsically Safe for installation in Zone 1, 2 Gas Group IIC, IIB, IIA T4

or Class I, Division 1, 2 Groups A, B, C, D, Temperature Code T4 and

Class I, Zone 1, 2 Groups IIC, IIB, IIA, Temperature Code T4

Hazardous Area/Hazardous Location.

• Universal inputs (mV, TC, RTD) from Zone 0, 1, 2 or

Class I, II, III, Division 1, 2, Groups A, B, C, D, E, F, G, and

Class I, Zone 0, 1, 2 Groups IIC, IIB, IIA Hazardous Location.

• Isolation of 200 V input to input (mV or TC), 60 V input to input (RTD)

and 500 V input to ground, allows grounded sensors.

• EMC Compatibility to EN61000-6-2, EN61000-6-4.

• ATEX, FM & FM-C, Russian and Ukrainian Certifications.

• High reliability, SMD components.

• High density, 16 channels per unit.

• Lower cables, installation and maintenance costs.

• 1 terminal block per input, no external terminal block required.

• Simplified installation using standard DIN Rail mounting units.