CY96F356RWBPMC-GS-UJE2中文资料英飞凌数据手册PDF规格书

特性 Features

■ Technology

❐ 0.18 μm CMOS

■ CPU

❐ F2MC-16FX CPU

❐ Up to 56 MHz internal, 17.8 ns instruction cycle time

❐ Optimized instruction set for controller applications (bit, byte,

word and long-word data types; 23 different addressing

modes; barrel shift; variety of pointers)

❐ 8-byte instruction execution queue

❐ Signed multiply (16-bit × 16-bit) and divide (32-bit/16-bit) instructions

available

■ System clock

❐ On-chip PLL clock multiplier (x1 - x25, x1 when PLL stop)

❐ 3 MHz - 16 MHz external crystal oscillator clock (maximum

frequency when using ceramic resonator depends on Q-factor).

❐ Up to 56 MHz external clock

❐ 32-100 kHz subsystem quartz clock

❐ 100 kHz/2 MHz internal RC clock for quick and safe startup,

oscillator stop detection, watchdog

❐ Clock source selectable from main- and subclock oscillator

(part number suffix “W”) and on-chip RC oscillator, independently

for CPU and 2 clock domains of peripherals.

❐ Low Power Consumption - 13 operating modes : (different

Run, Sleep, Timer modes, Stop mode)

❐ Clock modulator

■ On-chip voltage regulator

❐ Internal voltage regulator supports reduced internal MCU

voltage, offering low EMI and low power consumption figures

■ Low voltage reset

❐ Reset is generated when supply voltage is below minimum.

■ Code Security

❐ Protects ROM content from unintended read-out

■ Memory Patch Function

❐ Replaces ROM content

❐ Can also be used to implement embedded debug support

■ DMA

❐ Automatic transfer function independent of CPU, can be assigned

freely to resources

■ Interrupts

❐ Fast Interrupt processing

❐ 8 programmable priority levels

❐ Non-Maskable Interrupt (NMI)

■ Timers

❐ Three independent clock timers (23-bit RC clock timer, 23-bit

Main clock timer, 17-bit Sub clock timer)

❐ Watchdog Timer

■ CAN

❐ Supports CAN protocol version 2.0 part A and B

❐ ISO16845 certified

❐ Bit rates up to 1 Mbit/s

❐ 32 message objects

❐ Each message object has its own identifier mask

❐ Programmable FIFO mode (concatenation of message objects)

❐ Maskable interrupt

❐ Disabled Automatic Retransmission mode for Time Triggered

CAN applications

❐ Programmable loop-back mode for self-test operation

■ USART

❐ Full duplex USARTs (SCI/LIN)

❐ Wide range of baud rate settings using a dedicated reload

timer

❐ Special synchronous options for adapting to different synchronous

serial protocols

❐ LIN functionality working either as master or slave LIN device

■ I2C

❐ Up to 400 kbps

❐ Master and Slave functionality, 7-bit and 10-bit addressing

■ A/D converter

❐ SAR-type

❐ 10-bit resolution

❐ Signals interrupt on conversion end, single conversion mode,

continuous conversion mode, stop conversion mode, activation

by software, external trigger or reload timer