CM6533(N)中文资料USB audio codec with MCU, EQ, AGC, embedded crystal, flash and tri-color LED数据手册Cmedia规格书

描述 Description

The CM6533 is a USB 2.0 audio chip built-in 8051 for flexible applications. With integrated Tri-Colors PWM LED driver and two-channel ADC/DAC and S/PDIF interface that makes it suitable for headset, docking, speaker and microphone applications. The internal 8051 can also be developed to a lot of different applications, such as Microsoft™ Lync/Skype/VoIP device, Android Phone or Tablet/Slate docking device. The CM6533 is compatible with USB Audio Class 1.0 and USB 2.0 Full-Speed, thus it can plug & play without any additional software installation on major operating systems. The internal DAC and ADC support from 8 ~ 96 KHz sampling rate and 16/24 bits resolution.
The CM6533 integrates equalizer on both playback and recording paths to compensate the frequency response of microphone and headphone.
The CM6533 also integrates 256K Byte flash (Including 32KB F/W programming size) and crystal but requires few passive components to make a finish product. Thus, it can save the total BOM cost and PCB area can be smaller. 

特性 Features

●USB Compliance
·USB spec. 2.0 full-speed compatible and USB-IF certification
·USB audio device class spec. 1.0 compliant
·USB HID device class spec. 1.1 compliant

●Architecture
·USB suspend/resume support
·Embedded USB transceiver and power-on reset circuit
·256K Byte Flash and 32K Byte programming size supported for flexible customizing
·Integrates 5-Band Hardware Equalizer with up-to-4 preset modes 
·Built-in Automatic Gain Control (AGC) for microphone recording
·MCU / Flash / GPIO control via HID / Vender command interface (MCU read/write support 16 bytes data transfer bandwidth)
·Supports up to 12 GPIO pins
·Single 5V power supply with embedded 5V-to-4.5V and 5V-to-3.3V regulators

●Audio I/O
·2-channel DAC outputs with 16-ohms headphone amplifier (support from 8 ~ 96 KHz sampling rate and 16/24 bits resolution.)
·2-channel ADC inputs (support from 8 ~ 96 KHz sampling rate and 16/24 bits resolution.)
·Supports stereo microphone inputs with independent voltage bias pins and analog mixer (monitoring) function
·Supports ADC DC offset cancellation high-pass-filter
·Supports optional digital S/PDIF output
·Configurable USB audio topology to Headset/Speaker/Microphone modes by internal 8051 MCU

●Control Interfaces
·Featured with Microsoft® HID controls including Vol_Up / Vol_Dn / Playback_Mute / Record_Mute / Play_Pause / Stop / Previous / Next hot-key buttons (enabled by default)
·Optional analog DC VR volume control pin with internal ADC potentiometer
·I2C/SPI/UART master/slave mode control interface
·Supports Tri-color PWM LED indicator control pins(GPIO4,GPIO5,GPIO6)

●General
·Industrial standard small footprint LQFP-48 green package