CLVC374AQPWRG4Q1集成电路（IC）的触发器规格书PDF中文资料

CLVC374AQPWRG4Q1属于集成电路（IC）的触发器。由德州仪器制造生产的CLVC374AQPWRG4Q1触发器触发器是能够存储单个逻辑状态或信息“位”的基本数字存储器件。这些器件至少有两个输入；一个或多个用于传递要存储的数据，另一个用于指示存储该数据的时间点。不同的触发器类型，例如 D（延迟）、SR（置位复位）和 JK，对提供给其输入的信号有不同的响应，可用于实现不同的逻辑功能。这些器件与锁存器的不同之处在于它们是边缘敏感器件，其保持的逻辑状态仅在接收到有效时钟信号时才会改变。

1FEATURES

· Qualified for Automotive Applications

· ESD Protection Exceeds 2000 V Per

MIL-STD-883, Method 3015; Exceeds 200 V

Using Machine Model (C = 200 pF, R = 0)

· Operates From 2 V to 3.6 V

· Inputs Accept Voltages to 5.5 V

· Max tpd of 8.5 ns at 3.3 V

· Typical VOLP (Output Ground Bounce) < 0.8 V

at VCC = 3.3 V, TA = 25°C

· Typical VOHV (Output VOH Undershoot) > 2 V

at VCC = 3.3 V, TA = 25°C

· Supports Mixed-Mode Signal Operation on All

Ports (5-V Input/Output Voltage With 3.3-V VCC)

· Ioff Supports Partial-Power-Down Mode

Operation

DESCRIPTION/ORDERING INFORMATION

The SN74LVC374A octal edge-triggered D-type flip-flop is designed for 2.7-V to 3.6-V VCC operation.

This device features 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance

loads. This device is particularly suitable for implementing buffer registers, input/output (I/O) ports, bidirectional

bus drivers, and working registers.

On the positive transition of the clock (CLK) input, the Q outputs are set to the logic levels set up at the data (D)

inputs.

A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or

low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the

bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines

without interface or pullup components.

OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while

the outputs are in the high-impedance state.

Inputs can be driven from either 3.3-V or 5-V devices. This feature allows the use of this device as a translator in

a mixed 3.3-V/5-V system environment.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs,

preventing damaging current backflow through the device when it is powered down.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.