CDCVF25084中文资料具有 8 路输出的 3.3V x4 时钟倍频器数据手册TI规格书

描述 Description

The CDCVF25084 is a high-performance, low-skew, low-jitter, phase-lock loop clock multiplier. It uses a PLL to precisely align, in both frequency and phase, the output clocks to the input clock signal including a multiplication factor of four. The CDCVF25084 operates from a nominal supply voltage of 3.3 V. The device also includes integrated series-damping resistors in the output drivers that make it ideal for driving point-to-point loads.

Two banks of four outputs each provide low-skew, low-jitter copies of CLKIN x four. All outputs operate at the same frequency. Output duty cycles are adjusted to 50%, independent of duty cycle at CLKIN. The device automatically goes into power-down mode when no input signal is applied to CLKIN and the outputs go into a low state. Unlike many products containing PLLs, the CDCVF25084 does not require an external RC network. The loop filter for the PLL is included on-chip, minimizing component count, space, and cost.

Because it is based on a PLL circuitry, the CDCVF25084 requires a stabilization time to achieve phase lock of the feedback signal to the reference signal. This stabilization is required following power up and application of a fixed-frequency signal at CLKIN and any following changes to the PLL reference.

The CDCVF25084 is characterized for operation from –40°C to 85°C.

特性 Features

• Phase-Locked Loop-Based Multiplier by Four
• Input Frequency Range: 2.5 MHz to 45 MHz
• Output Frequency Range: 10 MHz to 180 MHz
• LVCMOS/LVTT I/O Compatible
• Low Jitter (Cycle-Cycle): ±120 ps Over the Range 75 MHz to 180 MHz
• Distributes One Clock Input to Two Banks of Four Outputs
• Auto Frequency Detection to Disable Device (Power-Down Mode)
• Operates From Single 3.3-V Supply
• Industrial Temperature Range –40°C to 85°C
• 25- On-Chip Series Damping Resistors
• No External RC Network Required
• Spread Spectrum Clock Compatible (SSC)
• Available in 16-Pin TSSOP Package