CDC2509B集成电路（IC）的时钟发生器PLL频率合成器规格书PDF中文资料

CDC2509B属于集成电路（IC）的时钟发生器PLL频率合成器。由美国德州仪器公司制造生产的CDC2509B时钟发生器，PLL，频率合成器时钟发生器、PLL 和频率合成器集成电路 (IC) 可为逻辑器件提供参考信号的稳定定时脉冲，这些器件包括计算机、微控制器、数据通信系统和图形/视频发生器。这些集成电路可能包括缓冲器、驱动器、分频器、倍频器、多路复用器、合成器、扇出分配器和预分频器。

Use CDCVF2509A as a Replacement for

this Device

Designed to Meet PC SDRAM Registered

DIMM Specification

Spread Spectrum Clock Compatible

Operating Frequency 25 MHz to 125 MHz

Phase Error Time Minus Jitter at 66 MHz to

100 MHz Is ±150 ps

Jitter (peak − peak) at 66 MHz to 100 MHz Is

±80 ps

Jitter (cycle − cycle) at 66 MHz to 100 MHz

Is |100 ps|

Available in Plastic 24-Pin TSSOP

Phase-Lock Loop Clock Distribution for

Synchronous DRAM Applications

Distributes One Clock Input to One Bank of

Five and One Bank of Four Outputs

Separate Output Enable for Each Output

Bank

External Feedback (FBIN) Terminal Is Used

to Synchronize the Outputs to the Clock

Input

On-Chip Series Damping Resistors

No External RC Network Required

Operates at 3.3 V

description

The CDC2509B is a high-performance, low-skew, low-jitter, phase-lock loop (PLL) clock drivers. They use a PLL

to precisely align, in both frequency and phase, the feedback (FBOUT) output to the clock (CLK) input signal.

They are specifically designed for use with synchronous DRAMs. The CDC2509B operates at 3.3-V VCC. They

also provide integrated series-damping resistors that make it ideal for driving point-to-point loads.

One bank of five outputs and one bank of four outputs provide nine low-skew, low-jitter copies of CLK. Output

signal duty cycles are adjusted to 50%, independent of the duty cycle at CLK. Each bank of outputs is enabled

or disabled separately via the control (1G and 2G) inputs. When the G inputs are high, the outputs switch in

phase and frequency with CLK; when the G inputs are low, the outputs are disabled to the logic-low state.

Unlike many products containing PLLs, the CDC2509B does not require external RC networks. The loop filter

for the PLL is included on-chip, minimizing component count, board space, and cost.

Because it is based on PLL circuitry, the CDC2509B requires a stabilization time to achieve phase lock of the

feedback signal to the reference signal. This stabilization time is required, following power up and application

of a fixed-frequency, fixed-phase signal at CLK, and following any changes to the PLL reference or feedback

signals. The PLL can be bypassed for test purposes by strapping AVCC to ground.