CD74HCT646M96.A中文资料德州仪器数据手册PDF规格书

2-V to 6-V VCC Operation (CD54HC646)

4.5-V to 5.5-V VCC Operation (CD74HCT646)

Wide Operating Temperature Range of

–55°C to 125°C

Balanced Propagation Delays and

Transition Times

Standard Outputs Drive Up To 15 LS-TTL

Loads

Significant Power Reduction Compared to

LS-TTL Logic ICs

Inputs Are TTL-Voltage Compatible

(CD74HCT646)

Independent Registers for A and B Buses

Multiplexed Real-Time and Stored Data

True Data Paths

description/ordering information

The CD54HC646 and CD74HCT646 consist of bus-transceiver circuits with 3-state outputs, D-type flip-flops,

and control circuitry arranged for multiplexed transmission of data directly from the input bus or from the internal

registers. Data on the A or B bus is clocked into the registers on the low-to-high transition of the appropriate

clock (CLKAB or CLKBA) input. Figure 1 illustrates the four fundamental bus-management functions that can

be performed with these devices.

Output-enable (OE) and direction-control (DIR) inputs control the transceiver functions. In the transceiver

mode, data present at the high-impedance port can be stored in either or both registers.

The select-control (SAB and SBA) inputs can multiplex stored and real-time (transparent mode) data. DIR

determines which bus receives data when OE is active (low). In the isolation mode (OE high), A data can be

stored in one register and/or B data can be stored in the other register.

When an output function is disabled, the input function still is enabled and can be used to store data. Only one

of the two buses, A or B, can be driven at a time.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.