CD74FCT374M集成电路（IC）的触发器规格书PDF中文资料

CD74FCT374M属于集成电路（IC）的触发器。由德州仪器制造生产的CD74FCT374M触发器触发器是能够存储单个逻辑状态或信息“位”的基本数字存储器件。这些器件至少有两个输入；一个或多个用于传递要存储的数据，另一个用于指示存储该数据的时间点。不同的触发器类型，例如 D（延迟）、SR（置位复位）和 JK，对提供给其输入的信号有不同的响应，可用于实现不同的逻辑功能。这些器件与锁存器的不同之处在于它们是边缘敏感器件，其保持的逻辑状态仅在接收到有效时钟信号时才会改变。

BiCMOS Technology With Low Quiescent

Power

3-State Outputs Drive Bus Lines Directly

Buffered Inputs

Noninverted Outputs

Input/Output Isolation From VCC

Controlled Output Edge Rates

48-mA Output Sink Current

Output Voltage Swing Limited to 3.7 V

SCR Latch-Up-Resistant BiCMOS Process

and Circuit Design

Package Options Include Plastic

Small-Outline (M) and Shrink Small-Outline

(SM) Packages and Standard Plastic (E) DIP

description

The CD74FCT374 is an octal, edge-triggered, D-type flip-flop that uses a small-geometry BiCMOS technology

and features 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance

loads. This device is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers,

and working registers.

The output stage is a combination of bipolar and CMOS transistors that limits the output high level to two diode

drops below VCC. This resultant lowering of output swing (0 V to 3.7 V) reduces power-bus ringing [a source

of electromagnetic interference (EMI)] and minimizes VCC bounce and ground bounce and their effects during

simultaneous output switching. The output configuration also enhances switching speed and is capable of

sinking 48 mA.

The eight flip-flops enter data into their registers on the low-to-high transition of the clock (CLK). The

output-enable (OE) input controls the 3-state outputs and is independent of the register operation. When OE

is high, the outputs are in the high-impedance state.

A buffered OE input can be used to place the eight outputs in either a normal logic state (high or low) or the

high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly.

The high-impedance state and the increased drive provide the capability to drive bus lines without interface or

pullup components.

OE does not affect internal operations of the flip-flop. Old data can be retained or new data can be entered while

the outputs are in the high-impedance state.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

The CD74FCT374 is characterized for operation from 0°C to 70°C.