BQ2083-V1P3数据手册TI中文资料规格书

描述 Description

The bq2083-V1P3 SBS-compliant gas gauge IC for battery pack or in-system installation maintains an accurate record of available charge in Li-ion or Li-polymer batteries. The bq2083-V1P3 monitors capacity and other critical parameters of the battery pack and reports the information to the system host controller over a serial communication bus. It is designed to work with the bq29311 analog front-end (AFE) protection IC to maximize functionality and safety and minimize component count and cost in smart battery circuits. Using information from the bq2083-V1P3, the host controller can manage remaining battery power to extend the system run time as much as possible.

The bq2083-V1P3 uses an integrating converter with continuous sampling for the measurement of battery charge and discharge currents. Optimized for coulomb counting in portable applications, the self-calibrating integrating converter has a resolution better than 3-nVh and an offset measurement error of less than 1-µV (typical). For voltage and temperature reporting, the bq2083-V1P3 uses a 16-bit A-to-D converter. In conjunction with the bq29311, the onboard ADC also monitors individual cell voltages in a battery pack and allows the bq2083-V1P3 to generate the control signals necessary to implement the cell balancing and the required safety protection for Li-ion and Li-polymer battery chemistries.

The bq2083-V1P3 supports the Smart Battery Data (SBData) commands and charge-control functions. It communicates data using the System Management Bus (SMBus) 2-wire protocol. The data available include the battery’s remaining capacity, temperature, voltage, current, and remaining run-time predictions. The bq2083-V1P3 provides LED drivers and a push-button input to depict remaining battery capacity from full to empty in 20%, 25%, or 33% increments with a 3-, 4-, or 5-segment display.

The bq2083-V1P3 contains 512 bytes of internal data flash memory, which store configuration information. The information includes nominal capacity and voltage, self-discharge rate, rate compensation factors, and other programmable cell-modeling factors used to accurately adjust remaining capacity for use-conditions based on time, rate, and temperature. The bq2083-V1P3 also automatically calibrates or learns the true battery capacity in the course of a discharge cycle from programmable near full to near empty levels.

The bq29311 AFE protection IC provides power to the bq2083-V1P3 from a 3 or 4 series Li-ion cell stack, eliminating the need for an external regulator circuit.

特性 Features

• Provides Accurate Measurement of Available Charge in Li-Ion and Li-Polymer Batteries
• Supports the Smart Battery Specification (SBS) V1.1
• Works With the TI bq29311 Analog Front End (AFE) Protection IC to Provide Complete Pack Electronics for 10.8-V or 14.4-V Battery Packs With Few External Components
• Based on a Powerful Low-Power RISC CPU Core With High-Performance Peripherals
• Integrated Flash Memory Eliminates the Need for External Configuration EEPROM
• Measures Charge Flow Using a High Resolution 16-Bit Integrating Converter
• Better Than 3-nVh of Resolution
• Self-Calibrating
• Offset Error Less Than 1-µV

• Uses 16-Bit Delta Sigma Converter for Accurate Voltage and Temperature Measurements
• Programmable Cell Modeling for Maximum Battery Fuel Gauge Accuracy
• Drives 3-, 4-, or 5-Segment LED Display for Remaining Capacity Indication
• 38-Pin TSSOP (DBT)
• APPLICATIONS
• Notebook PCs
• Medical and Test Equipment
• Portable Instrumentation

I&sups;C is a trademark of Phillips Electronics.