ATMEGA162L数据手册Microchip中文资料规格书

描述 Description

Overview
The ATmega162 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega162 achieves throughputs approaching 1 MIPS per MHz allowing the sys tem designer to optimize power consumption versus processing speed.

特性 Features

• High-performance, Low-power AVR® 8-bit Microcontroller
• Advanced RISC Architecture
   – 131 Powerful Instructions – Most Single-clock Cycle Execution
   – 32 x 8 General Purpose Working Registers
   – Fully Static Operation
   – Up to 16 MIPS Throughput at 16 MHz
   – On-chip 2-cycle Multiplier
• Non-volatile Program and Data Memories
   – 16K Bytes of In-System Self-programmable Flash Endurance: 10,000 Write/Erase Cycles
   – Optional Boot Code Section with Independent Lock Bits In-System Programming by On-chip Boot Program True Read-While-Write Operation
   – 512 Bytes EEPROM Endurance: 100,000 Write/Erase Cycles
   – 1K Bytes Internal SRAM
   – Up to 64K Bytes Optional External Memory Space
   – Programming Lock for Software Security
• JTAG (IEEE std. 1149.1 Compliant) Interface
   – Boundary-scan Capabilities According to the JTAG Standard
   – Extensive On-chip Debug Support
   – Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
• Peripheral Features
   – Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
   – Two 16-bit Timer/Counters with Separate Prescalers, Compare Modes, and Capture Modes
   – Real Time Counter with Separate Oscillator
   – Six PWM Channels
   – Dual Programmable Serial USARTs
   – Master/Slave SPI Serial Interface
   – Programmable Watchdog Timer with Separate On-chip Oscillator
   – On-chip Analog Comparator
• Special Microcontroller Features
   – Power-on Reset and Programmable Brown-out Detection
   – Internal Calibrated RC Oscillator
   – External and Internal Interrupt Sources
   – Five Sleep Modes: Idle, Power-save, Power-down, Standby, and Extended Standby
• I/O and Packages
   – 35 Programmable I/O Lines
   – 40-pin PDIP, 44-lead TQFP, and 44-pad MLF
• Operating Voltages
   – 1.8 - 5.5V for ATmega162V
   – 2.7 - 5.5V for ATmega162
• Speed Grades
   – 0 - 8 MHz for ATmega162V (see Figure 113 on page 265)
   – 0 - 16 MHz for ATmega162 (see Figure 114 on page 265)