AT90PWM1集成电路（IC）的微控制器规格书PDF中文资料

Overview

The AT90PWM1 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the AT90PWM1 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

特性 Features

• High Performance, Low Power AVR ® 8-bit Microcontroller

• Advanced RISC Architecture

– 131 Powerful Instructions - Most Single Clock Cycle Execution

– 32 x 8 General Purpose Working Registers

– Fully Static Operation

– Up to 1 MIPS throughput per MHz

– On-chip 2-cycle Multiplier

• Data and Non-Volatile Program Memory

– 8K Bytes Flash of In-System Programmable Program Memory

• Endurance: 10,000 Write/Erase Cycles

– Optional Boot Code Section with Independent Lock Bits

• In-System Programming by On-chip Boot Program

• True Read-While-Write Operation

– 512 Bytes of In-System Programmable EEPROM

• Endurance: 100,000 Write/Erase Cycles

– 512 Bytes Internal SRAM

– Programming Lock for Flash Program and EEPROM Data Security

• On Chip Debug Interface (debugWIRE)

• Peripheral Features

– Two 12-bit High Speed PSC (Power Stage Controllers) with 4-bit Resolution

Enhancement

• Non Overlapping Inverted PWM Output Pins With Flexible Dead-Time

• Variable PWM duty Cycle and Frequency

• Synchronous Update of all PWM Registers

• Auto Stop Function for Event Driven PFC Implementation

• Less than 25 Hz Step Width at 150 kHz Output Frequency

• PSC2 with four Output Pins and Output Matrix

– One 8-bit General purpose Timer/Counter with Separate Prescaler and Capture

Mode

– One 16-bit General purpose Timer/Counter with Separate Prescaler, Compare

Mode and Capture Mode

– Master/Slave SPI Serial Interface

– 10-bit ADC

• 8 Single Ended Channels and 1 Fully Differential ADC Channel Pair

• Programmable Gain (5x, 10x, 20x, 40x on Differential Channel)

• Internal Reference Voltage

– Two Analog Comparator with Resistor-Array to Adjust Comparison Voltage

– 4 External Interrupts

– Programmable Watchdog Timer with Separate On-Chip Oscillator

• Special Microcontroller Features

– Low Power Idle, Noise Reduction, and Power Down Modes

– Power On Reset and Programmable Brown Out Detection

– Flag Array in Bit-programmable I/O Space (4 bytes)

– In-System Programmable via SPI Port

– Internal Calibrated RC Oscillator ( 8 MHz)

– On-chip PLL for fast PWM ( 32 MHz, 64 MHz) and CPU (16 MHz)

• Operating Voltage: 2.7V - 5.5V

• Extended Operating Temperature:

– -40°C to +105°