ALC3261-CG中文资料瑞昱数据手册PDF规格书

描述 Description

The ALC3261 is a low power, dual I2S interface, 4 channels DAC and 2 channel ADC Audio Codec with

a optimized Voice DSP integrated. The primary I2S interface connects to system host chip and its

secondary I2S interface can perform as input or output device connected to external processor, blue tooth

device or wireless transceiver.

ALC3261 is a highly integration of audio subsystem chip, including two stereo DACs with 100dB SNR,

one stereo ADC with 94dB SNR, stereo Class-D speaker amplifiers provides 1.5W per channel into 8Ω or

2.5W per channel into 4Ω with a 5V supply with excellent PSRR and low EMI, a mono differential

earpiece amplifier is also provided, providing output from any DAC or Analog-in.

The ALC3261 features an extra low power cap-free headphone amplifier. It consumes only less than

10mW power during playback, providing tablet system longer battery life under headphone listening

mode.

The integrated DRC (Dynamic Range Controller) and parametric Equalizer provides further digital sound

processing capability of audio playback paths. The DRC in ALC3261 continuously monitors the DAC

output level. When the power level is low, it increases the input signal gain to make it sound louder. At

the same time, if a peaking signal is detected, it autonomously reduces the applied gain to avoid hard

clipping. It ensures the maximum/consistent signal amplitude without producing audio clipping and

speaker damage. The parametric Equalizer contains 7 independent filters with programmable gain, center

frequency and bandwidth to tailor the frequency characteristics of embedded speaker system according to

user preferences.

ALC3261 embedded a low power wideband voice DSP. This optimized voice DSP provides excellent

noise suppression, echo cancellation and beam forming performance. It combines 8 kHz and 16 kHz

sampling rate and 75MIPS digital signal processing capability to achieve high fidelity and non-stationary

wideband performance.

特性 Features

Two Stereo Digital-to-Analog Converters with 100dBA SNR

One Stereo Analog-to-Digital Converter with 94dBA SNR

Differential analog microphone inputs with boost pre-amplifiers and low noise microphone bias

 +20/+24/+30/+35/+40/+44/+50/+52 dB microphone boost gain

 MIC input to ADC with 50dB boost gain, SNR > 66dBA and THD+N < -65dB

 Adjustable microphone reference voltage (0.9*MICVDD or 0.75*MICVDD)

Stereo line level input

 Line level input to ADC with 0dB gain, SNR >= 94dBA, THD+N <= -83dB

Stereo line level output

 ADC to line level output with 0dB gain, SNR >= 100dBA, THD+N <= -86dB

Stereo/Mono BTL (Bridge-Tied-Load) Class-D amplifier

 650mW/CH (SPKVDD=3.6V, THD+N < = 1, 8 Load)

 500mW/CH (SPKVDD=3.6V, THD+N < = 0.1, 8 Load)

 1.2W/CH (SPKVDD=5.0V, THD+N < = 1, 8 Load)

 2.5W/CH (SPKVDD=5.0V, THD+N < = 10, 4 Load)

 2.1W/CH (SPKVDD=5.0V, THD+N < = 1, 4 Load)

 Auto speaker ratio gain for SPKVDD = 3.3V ~ 5.0V

Stereo Cap-Free headphone amplifier with extra low power consumption for playback

 20mW/CH (AVDD=CPVDD=1.8V, THD+N <= -80dB, 16 Load)

 Playback power consumption <= 10mW (AVDD=VBVDD=CPVDD=1.8V, 16, With I2S

Clock, Playback Silence)

 Playback power consumption <= 13mW (AVDD=VBVDD=CPVDD=1.8V, 16, With I2S

Clock, Playback 1mW/channel to 32 headphone)

Mono differential receiver amplifier

 50mW/CH (AVDD=CPVDD=1.8V, THD+N <= -70dB, 16 Load, BTL mode)

Audio jack insert detection

Inside PLL can receiver wide range clock input

Two 24bit/8kHz ~ 192kHz I2S/PCM interface for each mono DAC and stereo DAC

Two 24bit/8kHz ~ 192kHz I2S/PCM interface for stereo ADC

I2C control interface

Two digital microphone interfaces supported

Asynchronous sample rate converter (ASRC) for each interface

Programmable register table with two sequencers

7-bands parametric equalizer (EQ) for DAC path or ADC path

Enhanced DRC(Dynamic Range Control)/AGC(Auto Gain Control) with compression function for

DAC path or ADC path

Zero detection and soft volume for pop noise suppression

Speaker amplifier DC term self-test function for speaker protection

Voice Processing

 Noise Reduction

 Beam Forming with Stereo Microphone

 Far Field Pick-Up Technology

Application

Smart Phones

Tablet