ADUM5202ARWZ-RL中文资料亚德诺数据手册PDF规格书

FEATURES

Qualified for automotive applications

isoPower integrated, isolated dc-to-dc converter

Regulated 3.3 V or 5 V output

Up to 400 mW output power

Dual, dc-to-25 Mbps (NRZ) signal isolation channels

16-lead SOIC package with 7.6 mm creepage

High temperature operation: 105°C maximum

High common-mode transient immunity: >25 kV/µs

Safety and regulatory approvals

UL recognition

2500 V rms for 1 minute per UL 1577

CSA Component Acceptance Notice #5A)

VDE certificate of conformity

IEC 60747-5-2 (VDE 0884, Part 2):2003-01

VIORM = 560 VPEAK

APPLICATIONS

Industrial field bus isolation

Power supply start-up bias and gate drives

Isolated sensor interfaces

Automotive systems

GENERAL DESCRIPTION

The ADuM5200W/ADuM5201W/ADuM5202W1 are dualchannel digital isolators with isoPower®, an integrated, isolated dcto-dc converter. Based on the Analog Devices, Inc., iCoupler®

technology, the dc-to-dc converter provides up to 500 mW of

regulated, isolated power at either 5.0 V or 3.3 V from a 5.0 V input

supply, or 3.3 V from a 3.3 V supply at the power levels shown in

Table 1. These devices eliminate the need for a separate, isolated

dc-to-dc converter in low power isolated designs. The iCoupler

chip-scale transformer technology is used to isolate the logic

signals and for the magnetic components of the dc-to-dc

converter. The result is a small form factor, total isolation

solution.

The ADuM5200W/ADuM5201W/ADuM5202W isolators

provide two independent isolation channels in a variety of channel

configurations and data rates (see the Ordering Guide for more

information).

isoPower uses high frequency switching elements to transfer power

through its transformer. Special care must be taken during printed

circuit board (PCB) layout to meet emissions standards. See the

AN-0971 Application Note for board layout recommendations.