ADM2867E_V01中文资料亚德诺数据手册PDF规格书

GENERAL DESCRIPTION

The ADM2861E, ADM2863E, ADM2865E, and ADM2867E are 5.7 kV rms signal and power isolated RS-485 transceivers. These devices are designed for balanced transmission lines and comply with ANSI/TIA/EIA-485-A-98 and ISO 8482:1987(E). The devices pass radiated emissions testing to the EN 55032 Class B standard with margin on a 2-layer printed circuit board (PCB) using two small external 0402 ferrites on isolated power and ground pins. The device features an integrated, low electromagnetic interference (EMI), isolated dc-to-dc converter, which eliminates the need for an external isolated power supply. The isolation barrier provides immunity to system level electromagnetic compatibility (EMC) standards. The family of isolator devices features ±12 kV contact and ±15 kV air IEC61000-4-2 ESD protection on the RS-485 A, B, Y, and Z pins. The devices also features cable invert pins, allowing the user to quickly correct reversed cable connection on the A, B, Y, and Z bus pins while maintaining full receiver fail-safe performance.

Slew rate limited versions are available, which are optimized for low speed over long cable runs, and have a maximum data rate of 500 kbps. Half duplex and full duplex variants are available. The full duplex generics allow independent cable inversion of the driver and receiver for additional flexibility.

Table 18 shows the summary description of each generic.

FEATURES

5.7 kV rms isolated RS-485/RS-422 transceiver

Low radiated emissions, integrated, isolated dc-to-dc converter

Passes EN 55032 Class B with margin on a 2-layer PCB

Cable invert smart feature

Correct reversed cable connection on A, B, Y, and Z bus pins while maintaining full receiver fail-safe feature

ESD protection on RS-485 A, B, Y, and Z pins

≥±12 kV IEC61000-4-2 contact discharge

≥±15 kV IEC61000-4-2 air discharge

High speed 25 Mbps data rate (ADM2865E/ADM2867E)

Low speed 500 kbps data rate for EMI control (ADM2861E/ADM2863E)

Flexible power supplies

Input VCC supply of 3 V to 5.5 V

Logic VIO supply of 1.7 V to 5.5 V

VSEL pin to select VISO supply of 5 V (VCC > 4.5 V) or 3.3 V

PROFIBUS compliant for 5 V VISO

Wide operating temperature range: −40°C to +105°C

High common-mode transient immunity: 250 kV/μs

Short-circuit, open-circuit, and floating input receiver fail-safe

Supports 192 bus nodes (72 kΩ receiver input impedance)

Full hot swap support (glitch free power-up/power-down)

Safety and regulatory approvals (pending)

CSA Component Acceptance Notice 5A, DIN V VDE V 0884-11, UL 1577, CQC11-471543-2012, IEC 61010-1

Complies with ANSI/TIA/EIA-485-A-98 and ISO 8482:1987(E)

28-lead, fine pitch SOIC_W package (10.15 mm × 10.05 mm) with >8.0 mm creepage and clearance

APPLICATIONS

Heating, ventilation, and air conditioning (HVAC) networks

Industrial field buses

Building automation

Utility networks

Energy meters