ADM1028ARQ集成电路（IC）的热管理规格书PDF中文资料

GENERAL DESCRIPTION

The ADM1028 is a low-cost temperature monitor and fan controller for microprocessor-based systems. The temperature of a remote sensor diode may be measured, allowing monitoring of processor temperature in single processor systems. An on-chip temperature sensor monitors ambient system temperature.

Measured values can be read out via the System Management Bus, and values for limit comparisons can be programmed in over the same serial bus.

The ADM1028 also contains a DAC for fan speed control. An automatic hardware temperature trip point is provided and the fan will be driven to full speed if it is exceeded. A Ramp Rate Register is provided to control the rate with which fan speed is increased or decreased. This is to eliminate sudden changes in fan speed, thereby reducing fan acoustics and prolonging the fan’s life.

FEATURES

On-Chip Temperature Sensor

External Temperature Measurement with Remote Diode

Interrupt and Over-Temperature Outputs

Fault-Tolerant Fan Control with Auto Hardware Trip Point

Remote Reset and Power-Down Functions

LDCM Support

System Management Bus (SMBus) Communications

Standby Mode to Minimize Power Consumption

Limit Comparison of all Monitored Values

DAC Output for Linear Fan Speed Control

Ramp Rate Register for Control of Rate of Change of Fan Speed, Reduction of Fan Acoustics

APPLICATIONS

Network Servers and Personal Computers

Microprocessor-Based Office Equipment

Test Equipment and Measuring Instruments