ADC08D502集成电路（IC）的模数转换器（ADC）规格书PDF中文资料

ADC08D502属于集成电路（IC）的模数转换器（ADC）。由德州仪器制造生产的ADC08D502模数转换器（ADC）模数转换器（ADC、A/D 或 A 转 D）对模拟信号进行采样，例如由麦克风采集的声音或传感器的输出，然后将其转换为数字信号。一般来说，数字输出是二进制补码二进制数，与输入成比例。输入类型可能是差分、伪差分或单端输入。模数转换器可按照位数、采样率、输入数、接口、转换器数和架构（例如自适应增量、双斜率、折叠、流水线、SAR、三角积分、两步式）进行选择。

1FEATURES

2• Internal Sample-and-Hold

• Single +1.9V ±0.1V Operation

• Choice of SDR or DDR Output Clocking

• Multiple ADC Synchronization Capability

• Specified No Missing Codes

• Serial Interface for Extended Control

• Fine Adjustment of Input Full-Scale Range and

Offset self•

Duty Cycle Corrected Sample Clock

APPLICATIONS

• Direct RF Down Conversion

• Digital Oscilloscopes

• Satellite Set-top boxes

• Communications Systems

• Test Instrumentation

KEY SPECIFICATIONS

• Resolution: 8 Bits

• Max Conversion Rate: 500 MSPS (min)

• Bit Error Rate: 10-18 (typ)

• ENOB @ 250 MHz Input: 7.5 Bits (typ)

• DNL: ±0.15 LSB (typ)

• Power Consumption

– Operating: 1.4 W (typ)

– Power Down Mode: 3.5 mW (typ)

DESCRIPTION

The ADC08D502 is a dual, low power, high

performance CMOS analog-to-digital converter that

digitizes signals to 8 bits resolution at sampling rates

up to 500 MSPS. Consuming a typical 1.4 Watts at

500 MSPS from a single 1.9 Volt supply, this device

is specified to have no missing codes over the full operating temperature range. The unique folding and

interpolating architecture, the fully differential

comparator design, the innovative design of the

internal sample-and-hold amplifier and the self•

calibration scheme enable a very flat response of all dynamic parameters beyond Nyquist, producing a

high 7.5 ENOB with a 250 MHz input signal and a

500 MHz sample rate while providing a 10-18 B.E.R.

Output formatting is offset binary and the LVDS

digital outputs are compatible with IEEE 1596.3-1996, with the exception of an adjustable common mode

voltage between 0.8V and 1.2V.

Each converter has a 1:2 demultiplexer that feeds

two LVDS buses and reduces the output data rate on

each bus to half the sampling rate.

The converter typically consumes less than 3.5 mW

in the Power Down Mode and is available in a 128-

lead, thermally enhanced exposed pad HLQFP and

operates over the Industrial (-40°C ≤ TA ≤ +85°C)

temperature range.