22 μA, RRIO, CMOS, 18 V Operational Amplifier

FEATURES Micropower at high voltage (18 V): 22 μA maximum Low input bias current: 20 pA maximum Gain bandwidth product: 240 kHz at AV =100 typical Unity-gain crossover: 240 kHz −3 dB closed-loop bandwidth: 310 kHz Slew rate: 80 V/ms Large signal voltage gain: 110 dB minimum Single-supply operat

文件：709.49 Kbytes 页数：24 Pages

AD

亚德诺

10 μA, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

FEATURES PSRR: 100 dB minimum CMRR: 105 dB typical Very low supply current: 10 μA per amplifier maximum 1.8 V to 5 V single-supply or ±0.9 V to ±2.5 V dual-supply operation Rail-to-rail input and output 3 mV offset voltage maximum Very low input bias current: 0.5 pA typical APPLICATIONS Pres

文件：856.06 Kbytes 页数：24 Pages

AD

亚德诺

10 UA, Rail-to-Rail I/O, Zero InputCrossover Distortion Amplifiers

文件：846.26 Kbytes 页数：24 Pages

AD

亚德诺

22 關A, RRIO, CMOS, 18 V

文件：696.47 Kbytes 页数：24 Pages

AD

亚德诺

10µA、轨到轨I/O、零输入交越失真放大器

ADA4505-1/ADA4505-2/ADA4505-4分别是单通道、双通道和四通道微功耗放大器，具有轨到轨输入和输出摆幅特性，采用1.8 V至5 V单电源供电或±0.9 V至±2.5 V双电源供电。\n\n 这几款放大器采用新的电路技术，每个低成本放大器的工作电源电流小于10 μA时，可实现零输入交越失真（出色的PSRR和CMRR性能）和极低偏置电流。\n\n ADA4505-x放大器这种特性组合使其成为电池供电应用的完美之选，它们可以在电池的寿命期内将电源电压变化引起的误差降至低点，甚至对于轨到轨运算放大器，仍可保持高CMRR。\n\n 远程电池供电传感器、 • 电源抑制比（PSRR）：100 dB（最小值）\n• 共模抑制比（CMRR）：105 dB（典型值）\n• 极低电源电流：每个放大器10 μA（最大值）\n• 1.8 V至5 V单电源或±0.9 V至±2.5 V双电源供电\n• 轨到轨输入和输出\n• 失调电压：3 mV（最大值）\n• 极低输入偏置电流：0.5 pA（典型值）;

ADI

亚德诺

丝印：A2F；Package：WLCSP；10 μA, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

FEATURES PSRR: 100 dB minimum CMRR: 105 dB typical Very low supply current: 10 μA per amplifier maximum 1.8 V to 5 V single-supply or ±0.9 V to ±2.5 V dual-supply operation Rail-to-rail input and output 3 mV offset voltage maximum Very low input bias current: 0.5 pA typical APPLICATIONS Pres

文件：856.06 Kbytes 页数：24 Pages

AD

亚德诺

丝印：A2F；Package：WLCSP；10 μA, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

FEATURES PSRR: 100 dB minimum CMRR: 105 dB typical Very low supply current: 10 μA per amplifier maximum 1.8 V to 5 V single-supply or ±0.9 V to ±2.5 V dual-supply operation Rail-to-rail input and output 3 mV offset voltage maximum Very low input bias current: 0.5 pA typical APPLICATIONS Pres

文件：856.06 Kbytes 页数：24 Pages

AD

亚德诺

丝印：A2D；Package：SOT-23；10 μA, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

FEATURES PSRR: 100 dB minimum CMRR: 105 dB typical Very low supply current: 10 μA per amplifier maximum 1.8 V to 5 V single-supply or ±0.9 V to ±2.5 V dual-supply operation Rail-to-rail input and output 3 mV offset voltage maximum Very low input bias current: 0.5 pA typical APPLICATIONS Pres

文件：856.06 Kbytes 页数：24 Pages

AD

亚德诺

丝印：A2D；Package：SOT-23；10 μA, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

FEATURES PSRR: 100 dB minimum CMRR: 105 dB typical Very low supply current: 10 μA per amplifier maximum 1.8 V to 5 V single-supply or ±0.9 V to ±2.5 V dual-supply operation Rail-to-rail input and output 3 mV offset voltage maximum Very low input bias current: 0.5 pA typical APPLICATIONS Pres

文件：856.06 Kbytes 页数：24 Pages

AD

亚德诺

丝印：A2D；Package：SOT-23；10 μA, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

FEATURES PSRR: 100 dB minimum CMRR: 105 dB typical Very low supply current: 10 μA per amplifier maximum 1.8 V to 5 V single-supply or ±0.9 V to ±2.5 V dual-supply operation Rail-to-rail input and output 3 mV offset voltage maximum Very low input bias current: 0.5 pA typical APPLICATIONS Pres

文件：856.06 Kbytes 页数：24 Pages

AD

亚德诺