Precision, Dual-Channel, JFET Input Rail-to-Rail Instrumentation Amplifier

GENERAL DESCRIPTION The AD8253 is an instrumentation amplifier with digitally programmable gains that has GΩ input impedance, low output noise, and low distortion making it suitable for interfacing with sensors and driving high sample rate analog-to-digital converters (ADCs). It has high bandwidt

文件：1.37627 Mbytes 页数：27 Pages

AD

亚德诺

Wide Supply Range, Rail-to-Rail Output Instrumentation Amplifier

GENERAL DESCRIPTION The AD8426 is a dual-channel, low cost, wide supply range instrumentation amplifier that requires only one external resistor to set any gain from 1 to 1000. The AD8426 is designed to work with a variety of signal voltages. A wide input range and rail-to-rail output allow the

文件：284.57 Kbytes 页数：20 Pages

AD

亚德诺

Low Noise, Low Gain Drift, G = 2000 Instrumentation Amplifier

GENERAL DESCRIPTION The AD8428 is an ultralow noise instrumentation amplifier designed to accurately measure tiny, high speed signals. It delivers industry-leading gain accuracy, noise, and bandwidth. All gain setting resistors for the AD8428 are internal to the part and are precisely matched. C

文件：378.74 Kbytes 页数：20 Pages

AD

亚德诺

Precision, Dual-Channel, JFET Input, Rail-to-Rail Instrumentation Amplifier

文件：838.42 Kbytes 页数：28 Pages

AD

亚德诺

Wide Supply Range, Micropower,

文件：529.22 Kbytes 页数：28 Pages

AD

亚德诺

Wide Supply Range, Rail-to-Rail

文件：805.88 Kbytes 页数：28 Pages

AD

亚德诺

Precision, Dual-Channel, JFET Input Rail-to-Rail Instrumentation Amplifier

文件：864.6 Kbytes 页数：28 Pages

AD

亚德诺

Zero Drift, Digitally Programmable Instrumentation Amplifier

文件：725.71 Kbytes 页数：24 Pages

AD

亚德诺

精密、双通道、JFET输入、轨到轨仪表放大器

AD8224是第一款单电源、JFET输入仪表放大器，采用节省空间的4 mm x 4 mm、16引脚LFCSP封装。它所需的电路板面积与典型的单通道仪表放大器相同，但通道密度却提高一倍，每个通道的成本更低，且性能不受影响。 它针对高性能、便携式仪器的需要而设计，直流时的最小共模抑制比(CMRR)为86 dB，在10 kHz、G = 1时的最小CMRR为80 dB。最大输入偏置电流为10 pA，在整个工业温度范围内通常保持在300 pA以下。虽然采用JFET输入，但AD8224的噪声转折频率典型值仅为10 Hz。\n\n 随着混合信号处理技术日益普及，各系统所需的电源数量也不断 • 带有隐藏焊盘的定制LFCSP封装\n• 允许在封装下面布局走线和过孔\n\n• 允许全偏置电流性能\n\n\n\n\n• 低输入电流\n• 输入偏置电流：10 pA（最大值，B级）\n\n• 输入失调电流：0.6 pA（最大值，B级）\n\n\n\n\n• G = 10 (B Grade)\n（最小值，G = 10，B级）\nCMRR：90 dB\n（最小值，至10 kHz，G = 10，B级）\n\n• 双通道，小型\n4 mm × 4 mm LFCSP封装\n\n• 出色的交流特性、低功耗 \n\n• 带宽：1.5 MHz (G = 1)\n\n• 输入噪声：14 nV/√Hz (1 ;

ADI

亚德诺

10 MHz, 20 V/關s, G = 1, 10, 100, 1000 i CMOS짰 Programmable Gain Instrumentation Amplifier

GENERAL DESCRIPTION The AD8253 is an instrumentation amplifier with digitally programmable gains that has GΩ input impedance, low output noise, and low distortion making it suitable for interfacing with sensors and driving high sample rate analog-to-digital converters (ADCs). It has high bandwidt

文件：217.53 Kbytes 页数：10 Pages

AD

亚德诺