AD5203集成电路（IC）的数字电位计规格书PDF中文资料

AD5203属于集成电路（IC）的数字电位计。由亚德诺半导体技术有限公司制造生产的AD5203数字电位计数字电位器是一系列集成电路器件，可提供类似于传统机械电位器或变阻器的可调节电阻，但通过电子信号而非机械输入来进行控制。虽然这些器件的电阻可耗散的电能相对有限，但其电子控制能力有助于小型化、自动化和远程控制信号级模拟电路，而这些电路本来可能会使用机械电位器。

GENERAL DESCRIPTION

The AD5232 device provides a nonvolatile, dual-channel, digitally controlled variable resistor (VR) with 256-position resolution. This device performs the same electronic adjustment function as a mechanical potentiometer with enhanced resolution, solid state reliability, and superior low temperature coefficient performance. The versatile programming of the AD5232, per ormed via a microcontroller, allows multiple modes of operation and adjustment.

In the direct program mode, a predetermined setting of the RDAC registers (RDAC1 and RDAC2) can be loaded directly from the microcontroller. Another important mode of operation allows the RDACx register to be refreshed with the setting previously stored in the corresponding EEMEM register (EEMEM1 and EEMEM2). When changes are made to the RDACx register to establish a new wiper position, the value of the setting can be saved into the EEMEMx register by executing an EEMEM save operation. After the settings are saved in the EEMEMx register, these values are automatically transferred to the RDACx register to set the wiper position at system power-on. Such operation is enabled by the internal preset strobe. The preset strobe can also be accessed externally.

FEATURES

Dual-channel, 256-position resolution

10 kΩ, 50 kΩ, and 100 kΩ nominal terminal resistance

Nonvolatile memory maintenance of wiper settings

Predefined linear increment/decrement instructions

Predefined ±6 dB step log taper increment/decrement

instructions

SPI-compatible serial interface

Wiper settings and EEMEM readback

3 V to 5 V single-supply operation

±2.5 V dual-supply operation

14 bytes of general-purpose user EEMEM

Permanent memory write protection

100-year typical data retention (TA = 55°C)

APPLICATIONS

Mechanical potentiometer replacement

Instrumentation: gain and offset adjustment

Programmable voltage-to-current conversion

Programmable filters, delays, and time constants

Programmable power supply

Low resolution DAC replacement

Sensor calibration