AD009-06H中文资料ETC数据手册PDF规格书

1. General Descriptions

The AD009-041 a high-performance 4-bit RISC micro-controller embedded up to 2KX12 bits OTP, 32X4

bits SRAM, 10 Input/Output pins, one input pin and built-in one IR LED drive pin. it’s flexible and costeffective

solution for remote control of TV, Fans, Air conditioners ... etc.

2. Features

 MCU Operating voltage: 1.8V to 3.6V

 Operation frequency: MCU run 2 MIPS

 Memory Size

 Program ROM size: 2K X12 bits (OTP type)

SRAM size: 32x4 bits

 Wake up function for power-down mode

 HALT mode wake up source: RTC timer overflow or PA0~3, PB0~3 and PD0~3 edge trigger.

 Provided 10 input /output pins: each I/O has bit programmable as input or output port, these 10 I/Os

also provided edge trigger wake up function and pull up resistors configured by registers.

(a) They are provided with high sink current 20mA @VDD=3V, VOL=0.5V.

(b) They are provided with drive current 7mA @VDD=3V, VOH=2.5V.

(c) Pull up 150k ohm resistor.

 Provide 1 input pin (PA3) shared with VPP pin, pull up 150k ohm resistor and edge trigger wake up

function.

 Built-in one IR LED drive pin.

( Sink current : IOL=210mA at VDD=3V and VOL=0.3V )

 One 8 bits timer, clock source of timer is FMCK /8192( or 4096,2048,1024 ), the content of timer can be

cleared and read by program.

 Built-in internal RC OSC 8 MHz ----

frequency deviation within ±2, VDD=1.8V~3.6V, temp= -20 ºC ~70 ºC

 Support 1.5 cycle length instruction (NOP15) to generate IR waveform by software.

 Four reset condition

 Low voltage reset (LVR=1.5V)

 Power on RC-reset

 Watch dog timer overflow reset ( WDT period is 0.26 Sec )