74ACT16657DLR.A中文资料德州仪器数据手册PDF规格书

Members of the Texas Instruments

WidebusE Family

Inputs Are TTL-Voltage Compatible

Flow-Through Architecture Optimizes

PCB Layout

Distributed VCC and GND Pin Configuration

Minimizes High-Speed Switching Noise

EPICE (Enhanced-Performance Implanted

CMOS) 1-mm Process

500-mA Typical Latch-Up Immunity at

125°C

Package Options Include Plastic 300-mil

Shrink Small-Outline (DL) Packages Using

25-mil Center-to-Center Pin Spacings and

380-mil Fine-Pitch Ceramic Flat (WD)

Packages Using 25-mil Center-to-Center

Pin Spacings

description

The ’ACT16657 contain two noninverting octal

transceiver sections with separate parity

generator/checker circuits and control signals.

For either section, the transmit/receive (1T/R or

2T/R) input determines the direction of data flow.

When 1T/R (or 2T/R) is high, data flows from the

1A (or 2A) port to the 1B (or 2B) port (transmit

mode); when 1T/R (or 2T/R) is low, data flows

from the 1B (or 2B) port to the 1A (or 2A) port

(receive mode). When the output-enable (1OE or

2OE) input is high, both the 1A (or 2A) and 1B (or

2B) ports are in the high-impedance state.

Odd or even parity is selected by a logic high or

low level, respectively, on the 1ODD/EVEN (or

2ODD/EVEN) input. 1PARITY (or 2PARITY)

carries the parity bit value; it is an output from the

parity generator/checker in the transmit mode and

an input to the parity generator/checker in the

receive mode.

In the transmit mode, after the 1A (or 2A) bus is polled to determine the number of high bits, 1PARITY (or

2PARITY) is set to the logic level that maintains the parity sense selected by the level at the 1ODD/EVEN (or

2ODD/EVEN) input. For example, if 1ODD/EVEN is low (even parity selected) and there are five high bits on

the 1A bus, then 1PARITY is set to the logic high level so that an even number of the nine total bits (eight 1A-bus

bits plus parity bit) are high.