2901-01

Insert Molded Coil

Features: 1.Plasticmolded. 2.Highreliability. 3.Lowcost. Measurement: 1.QandLmeasuredwith½”longofTCW#16solderedalongthecoilleadsandwithoneendflushwiththebottomofthecoilthenbent¼”downfromstandoffatanangleof90°. 2.Lmin.measuredwithcorehalfwayou

2901-01

Insert Molded Coil;

Features:\n1. Plastic molded.\n2. High reliability.\n3. Low cost.Measurement:\n1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°.\n2. L min. measured with core halfway out of the top of the form.\n3. Inductance greater than 0.1uH read at recommended Q meter frequency.\n4. Inductance below 0.1uH calculated from readings taken at 50MHz.